These replacement parts are just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

Wheel Bearing & Hub Specifications:

  • Come as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT
  • 3 Bolt Flanges
  • Fit 5 Lug Wheels
  • Wheel Mounting Studs already installed
  • Include ABS Sensors and Plug Wires
  • Fits models with Automatic Transmission only

Axle Shaft Specifications:

  • Comes as a PAIR
    • Both LH (Driver Side) & RH (Passenger Side) FRONT
  • Not remanufactured
  • No core charges
  • Overall Length: 21-3/16"

Tie Rod Specifications:

  • Comes as a PAIR
    • Fits both LH (Driver Side) & RH (Passenger Side) FRONT OUTER
  • Comes as shown with greasable joints
Note: For the 2004-05 Malibu Classic requiring a VIN (Vehicle Identification Number), please match the 4th digit of your VIN number to the VIN code on your title. Your vehicles VIN number can be found in the lower left corner of the windshield or on your registration.

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible. This will ensure proper tracking and even tire wear.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (1:18)
    • Loosen the 19mm lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Remove the 35mm hub nut
    • Pull off the wheel
  2. step : Removing the Brake Caliper (1:50)
    • Remove the two 13mm bolts from the caliper
    • Pry off the caliper
    • Remove the brake rotor
  3. step : Removing the Hub (3:26)
    • Remove the three bolts that hold in the hub
    • Disconnect the ABS sensor if you have one
    • Reach in behind and remove the clip holding the hub
    • For the center, use a large axle nut socket
    • Once the center bolt is removed, simply pull the hub off the axle shaft
    • If it doesn't come off, you'll need an axle puller or a gear puller. Do not use a hammer
  4. step : Installing the Hub (9:26)
    • Once the new hub is ready, place it into position on the axle shaft
    • Take the original bolts and reattach the hub
  5. step : Step 5: Replacing the hub (9:26)
    • Once the new hub is ready, place it into position on the axle shaft.
    • Take the original bolts and reattach the hub.

Tools needed for replacement:

    Air Powered Tools

  • 3/8 Inch Air Impact Gun

  • General Tools

  • Floor Jack
  • Jack Stands

  • Ratchets & Related

  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 13mm Socket
  • 19mm Socket
  • 35mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(10:01 min)

Tools List:

    Air Powered Tools

  • 3/8 Inch Air Impact Gun

  • General Tools

  • Floor Jack
  • Jack Stands

  • Ratchets & Related

  • Socket Extensions
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 13mm Socket
  • 19mm Socket
  • 35mm Socket



This part replaces:

  • OE # 26055104
  • OE # 26086073
  • OE # 601243
  • OE # 601411
  • OE # 10379128
  • OE # 10379129
  • OE # 22692204
  • OE # 25844557
  • OE # 26059860
  • OE # 26066727
  • OE # 26091316
  • OE # 88957259
  • A1 Cardone 66-1243
  • Moog ES3455
  • Dorman 951-040
  • Hollander 538-01416
  • Reference Number 513137

Vehicle Fit

  • 2004-2005 Chevy Classic Front Suspension Kit 6 Piece Set for Models with Automatic Transmission Models with ABS Brakes
  • 1997-2003 Chevy Malibu Front Suspension Kit 6 Piece Set for Models with Automatic Transmission Models with ABS Brakes V6 3.1L
  • 1997-2003 Chevy Malibu Suspension Kit 6 Piece Set Front for Models with with ABS Brakes Automatic Transmission L4 2.4L
  • 1999-2004 Olds Alero Front Suspension Kit 6 Piece Set for Models with Automatic Transmission Models
  • 1997-1999 Olds Cutlass Front Suspension Kit 6 Piece Set for Models with Automatic Transmission Models excluding Supreme Models
  • 1999-2005 Pontiac Grand Am Front Suspension Kit 6 Piece Set for Models with Automatic Transmission Models
Part #: 1ASFK01901

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More