In the past, replacing struts required specialized tools to compress, remove and transfer the old spring and mount.  Pre-assembled with all new parts, our complete strut and spring assemblies make this job much quicker and easier for the do-it-yourself mechanic.

Each complete strut & spring assembly contains:

  • Upper Strut Mount
  • Strut Bearing
  • Coil Spring
  • Boot & Bumper Kit
  • Gas-charged Strut 

Pre-assembled, loaded strut & spring assemblies allow for a quicker, safer install than replacing with just bare struts. 

Trouble-Free Install

Trouble-free install includes the matched parts needed to get the job done. New mounts, bearings, springs and hardware will provide a better ride for your vehicle and save you time from not having to do the job again because a used part failed afterwards.

Matched Parts

When you buy the kit pre-built by us, you can be sure that the parts are matched for optimum performance.  Not all shocks and struts are manufactured the same, so mixing and matching can result in fit issues and potentially decrease the life of the parts.

Saves Time & Money

When you buy one of our kits, you not only save money over buying the parts individually, but you also save time having to search for all of the different parts that are correct for your vehicle (because we did it for you!)

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

3.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
Bushing alignment off
The lower bushing did not align with lower control arm. Had to rent a spring compressor to allow me to realign the bushing. That information would of be useful to have ahead of time.
August 2, 2017
9 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Them two bolts on the top of the spring plate, are the leveling bolts to put more pressure on sring?
Todd B on Feb 9, 2017
BEST ANSWER: These two bolts on top of the spring plate are mounting bolts to ensure a complete installation without use of other hardware.

Vehicle Fit

  • 2007-2012 Dodge Caliber (excluding SRT-4) Rear Strut & Spring Assembly Pair
  • 2007-2010 Jeep Compass (MK) Pair Strut & Spring Assembly Rear Front Wheel Drive
  • 2007-2010 Jeep Compass (MK) Rear Strut & Spring Assembly Pair 4 Wheel Drive (without Off Road Package)
  • 2007-2010 Jeep Patriot (MK) Rear Strut & Spring Assembly Pair 4 Wheel Drive (without Off Road Package)
  • 2007-2010 Jeep Patriot (MK) Pair Strut & Spring Assembly Rear Front Wheel Drive

This part replaces:

  • Hollander 527-01117
  • KYB SR4218
Part #: 1ASSP00977