Specifications: 

  • Brand New Steering Kit
  • Comes as a 7 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards
NOTE: For 2007 1500 truck models, the Classic Style has a crease down the center of the door skin where on the new body styles, the door skin is smooth. This part is for the classic body style truck.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:44)
    • Loosen the lug nut covers with a 22mm socket
    • Pry off the center cap by hand
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:10)
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • Make note of this measurement
    • Loosen the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Remove the 18mm nut from the outer tie rod end
    • Strike the steering knuckle with a hammer to loosen the outer tie rod
    • Pull the outer tie rod out of the steering knuckle
    • Hold the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Twist off the outer tie rod by hand
  3. step : Installing the New Outer Tie Rod (2:08)
    • Attach the grease fitting to the new outer tie rod
    • Tighten the grease fitting with a 7mm socket and ratchet
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the 18mm castle nut onto the outer tie rod
    • Push the cotter pin through the castle nut
    • Twist the cotter pin into place with needle nose pliers
    • Fill the tie rod with grease, using a grease gun
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • This should be the same as the measurement noted in Step 2
    • Tighten the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
  4. step : Reattaching the Wheel (3:33)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the center cap
    • Tighten the lug nut covers with a 22mm socket

Tools needed for replacement:

    General Tools

  • Hammer

  • Materials, Fluids, and Supplies

  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Adjustable Wrench
  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Specialty Tools

  • Grease Gun

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
1
0
0
0
Fantastic value.
Everything works great, and at a fraction of the cost. Only concern was non greaseable outer tierod ends.
September 4, 2017
Purchased
6 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Will this part fit a 2000 Chevy Silverado Ext Cab with Rack and Pinion Steering? The part seems to say it won't except for the Ext Cab. Little confusing.
Michael W on Dec 28, 2015
BEST ANSWER: For the 2000 Chevy Silverado 1500 you would have to have 4wd- This also excludes models with rack and pinion steering, and the crew cab model. So if you have rack and pinion on your extended cab model, this will not fit for your vehicle. You might be looking more for the kit, 1ASFK02546 a link is below. Thanks!

http://www.1aauto.com/steering-and-suspension-kit/i/1asfk02546?f=1019767&y=2000

How-to Video:

(04:28 min)

Tools List:

    General Tools

  • Hammer

  • Materials, Fluids, and Supplies

  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Adjustable Wrench
  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Specialty Tools

  • Grease Gun



This part replaces:

  • Moog ES3493T
  • Moog K6723
  • Moog ES3488
  • Moog K6534
  • Moog K6536
  • OE # 15295861, 26059210
  • OE # 19149615
  • OE # 12471378, 19149615
  • OE # 12471379
  • OE # 19149617

Vehicle Fit

  • 2002-2006 Cadillac Escalade 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2003-2006 Cadillac Escalade ESV 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2002-2006 Cadillac Escalade EXT 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2002-2006 Chevy Avalanche 1500 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 1999-2006 Chevy Silverado 1500 excluding Crew Cab 4 Wheel Drive 7 Piece Set Steering Kit for Models without Rack & Pinion Steering for Models with 4 Groove Pitman Arm
  • 2007 Chevy Silverado 1500 Classic excluding Crew Cab 4 Wheel Drive 7 Piece Set Steering Kit for Models without Rack & Pinion Steering for Models with 4 Groove Pitman Arm
  • 2000-2006 Chevy Suburban 1500 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2000 Chevy Tahoe excluding Z71 Models 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2001-2006 Chevy Tahoe 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 1999-2006 GMC Sierra 1500 excluding Crew Cab 4 Wheel Drive 7 Piece Set Steering Kit for Models without Rack & Pinion Steering for Models with 4 Groove Pitman Arm
  • 2007 GMC Sierra 1500 Classic excluding Crew Cab 4 Wheel Drive 7 Piece Set Steering Kit for Models without Rack & Pinion Steering for Models with 4 Groove Pitman Arm
  • 2000 GMC Yukon excluding Denali Models 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2001-2006 GMC Yukon 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
  • 2000-2006 GMC Yukon XL 1500 7 Piece Set Steering Kit for Models with 4 Groove Pitman Arm
Part #: 1ASFK01596

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More