Part Details

  • Bearing Type: Ball Bearing
  • Quantity: 4 Piece Set
  • Kit Includes:
    (2) Front Outer Tie Rods
    (2) Front Hub Assemblies

Specifications:

  • Comes as a 4 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacement
  • Built to strict quality control standards

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

  1. step : Remove the wheel and tire (1:18)
    • Raise and secure the vehicle.
    • Remove the lug nuts and then the wheel.
  2. step : Remove Caliper (2:07)
    • Turn wheels all the way in the opposite direction of the side you are working on.
    • Use your 13mm socket wrench to remove the caliper bolts.
    • Use a wire tie to help prevent stress on the caliper.
    • Use your 18mm socket to remove the brackets.
  3. step : Remove brake disk (4:13)
    • Take care not to touch the disk, and if you do make sure to clean it with rubbing alcohol or mineral spirits.
  4. step : Remove Hub (4:42)
    • Use a 35mm socket to remove the hub nut.
    • Give the axle a slight tap with a hammer to loosen it.
    • Remove the 3 bolts securing the hub using your 18mm socket and extension and ratchet or breaker bar.
    • You can use penetrating oil to help.
    • Disconnect your ABS sensor.
    • Use a rubber mallet to break your hub free, and work around the flange with the hammer to pull it off.
    • Remove the hub and shield.
    • Clean up any corrosion with a wire brush.
  5. step : Install new hub (9:10)
    • Use some penetrating oil to prep the knuckle for the new hub.
    • Put the three 18 mm bolts in place and tighten the nuts to 90 ft lbs.
    • Reinstall the ABS harness.
    • Tighten but don't torque the lug nut.
  6. step : Put brakes and wheel back on (11:50)
    • Remember to replace the lug nuts on in a star pattern.
    • Lug nuts tighten to 100-120 ft lbs
    • Hub nut is 103 ft lbs.
    • Make sure to check your brakes and steering before driving again.
    • Make sure to pump the brakes and seat your rotors.

Tools needed for replacement:

    General Tools

  • Floor Jack
  • Hammer
  • Jack Stands
  • Large C-Clamp
  • Rubber Mallet
  • Wire Brush

  • Materials, Fluids, and Supplies

  • Anti-Seize Grease
  • Rust Penetrant
  • Wire Ties

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 13mm Socket
  • 18mm Socket
  • 19mm Socket
  • 35mm Socket

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Great price
Fast shipping fit like original recommend product
April 8, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2004-2007Buick Rainier Buick Rainier 4 Piece Set Steering Kit
2003-2006Chevy SSR Chevy SSR 4 Piece Set Steering Kit
2002Chevy Trailblazer Chevy Trailblazer 4 Piece Set Steering Kit for Models with 16mm Thread Tie Rods
2003-2009Chevy Trailblazer Chevy Trailblazer 4 Piece Set Steering Kit
2003-2005Chevy Trailblazer EXT Chevy Trailblazer EXT 4 Piece Set Steering Kit
2002GMC Envoy GMC Envoy 4 Piece Set Steering Kit for Models with 16mm Thread Tie Rods
2003-2009GMC Envoy GMC Envoy 4 Piece Set Steering Kit
2003-2004GMC Envoy XL GMC Envoy XL 4 Piece Set Steering Kit
2003-2008Isuzu Ascender Isuzu Ascender 4 Piece Set Steering Kit
2002Oldsmobile Bravada Olds Bravada 4 Piece Set Steering Kit for Models with 16mm Thread Tie Rods
2003-2004Oldsmobile Bravada Olds Bravada 4 Piece Set Steering Kit
2005-2009Saab 9-7X Saab 9-7X 4 Piece Set Steering Kit

This part replaces:

  • Moog ES3675
  • Moog ES3676
  • Dorman 951-056
  • Hollander 538-01587
  • Reference Number 513188
  • OE # 12413037
  • OE # 15130858
  • OE # 26100286
  • OE # 26100287
Part #: 1AHTF00018


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(13:45 min)