Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

Part Details

  • Quantity:   8 Piece Set
  • Kit Includes:
      (2) Front Sway Bar Links
      (2) Front Outer Tie Rods
      (2) Front Upper Control Arms with Ball Joints
      (2) Front Inner Tie Rods

 

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Note: When replacing steering components, it is recommended to have a professional alignment performed on the vehicle afterwards. This will ensure proper tracking and even tire wear.

  1. step : Removing the Wheel (0:55)
    • Remove the center cap.
    • Loosen the lug nuts.
    • Raise the vehicle.
    • Remove the lug nuts.
    • Remove the wheel.
  2. step : Removing the Front Upper Control Arm (1:10)
    • Jack up the lower control arm to support the suspension.
    • Mark the upper bolts on the control arm with a marker to remember their alignment. Draw a line on the bolt and on to the bracket.
    • Remove the cotter pin from the balljoint.
    • Spray the ball join and upper bolts with penetrating oil.
    • Us a 21mm socket on the balljoint bolt. Hammer it on.
    • Use a breaker bar and pipe for added leverage to loosen the 21mm bolt. Don’t full remove the bolt.
    • Loosen the other two 21mm bolts using a socket and breaker bar.
    • Remove the nut from the balljoint and use a balljoint puller tool to separate the control arm and steering knuckle.
    • Use a 19mm to tighten the balljoint removal tool until it pops.
    • Remove the upper nuts and bolts.
    • Pull the control arm free.
  3. step : Installing the New Control Arm (7:18)
    • Use a wire brush where the control arm goes.
    • Put the new control arm in place.
    • Push it down onto the balljoint and start the bolts.
    • Reinsert the upper bolts. Line the marks up.
    • Torque Ball joint nut to 67ft/lbs.
    • Insert new cotter pin and use pliers to bend the end.
    • Put a grease fitting on and pump grease into the ball joint.
    • Raise the vehicle so all the weight is on the suspension.
    • Torque the upper bolts to 100ft/lbs.
  4. step : Reinstalling the Wheel (10:57)
    • Put the wheel in place.
    • Replace the lug nuts.
    • Lower the vehicle.
    • Tighten the lug nuts to 100ft/lbs in a star pattern.
    • Replace the center cap.

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • Marker / Writing Utensil

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • 1/2 Inch Breaker Bar
  • A Piece of Pipe (for leverage)

  • Sockets - Metric

  • 19mm Socket
  • 21mm Socket

  • Specialty Tools

  • Ball Joint Press

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
1997-2002Ford Expedition Ford Expedition Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
2004Ford F150 Heritage Truck Ford F150 Heritage Truck Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
1997-2003Ford F150 Truck Ford F150 Truck Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
1997-1999Ford F250 Light Duty Truck Ford F250 Light Duty Truck Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
2002Lincoln Blackwood Lincoln Blackwood Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
1998-2002Lincoln Navigator Lincoln Navigator Rear Wheel Drive Steering & Suspension Kit 8 Piece Set
Part #: 1ASFK06021


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(11:43 min)