Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Part Details

  • Kit Includes: (2) Front Sway Bar Links
  • Kit Includes: (2) Front Lower Ball Joints
  • Kit Includes: (2) Front Outer Tie Rods
  • Quantity: 14 Piece Set
  • Kit Includes: (1) Idler Arm
  • Kit Includes: (2) Front Upper Control Arms with Ball Joints
  • Kit Includes: (1) Pitman Arm
  • Kit Includes: (2) Tie Rod Adjusting Sleeves
  • Kit Includes: (2) Front Inner Tie Rods

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

  1. step : Remove the wheel (1:00)
    • Loosen the lug nuts.
    • Raise and secure the vehicle
    • Remove the lug nuts and the wheel.
  2. step : Remove the front shield (1:15)
    • Use a 15 mm socket and ratchet.
    • Remove the four bolts.
  3. step : Remove the Idler Arm (1:25)
    • Remove the 24 mm bolt securing the idler arm to the steering linkage
    • Use a joint fork and a hammer to separate the joint.
    • Remove the three other bolts securing the idler arm.
    • Use a Tie Rod Puller to pull apart the idler arm and the idler shaft.
  4. step : Install the new idler arm (4:34)
    • Assemble your new idler arm to your idler shaft, threading on the bushing and nut.
    • Bolt in the idler arm assembly into place, tightening up the three nuts.
    • Bolt in the end of the idler arm assembly to the steering gear.
    • Torque the nuts and bolts to 80 ft lbs.
    • Install the cotter pin.
    • Use a grease gun and fill the grease fitting.
  5. step : Reassembly (7:25)
    • Replace the shield with the four 15mm bolts.
    • Clip the air bag harness back in.
    • Put the wheel back on and lower the car
    • Using a star pattern torque the lug nuts to 120-140 ft lbs

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Large C-Clamp

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Sockets - Metric

  • 15mm Socket
  • 18mm Socket
  • 19mm Socket
  • 22mm Socket
  • 24mm Socket

  • Specialty Tools

  • Grease Gun
  • Tie Rod Fork
  • Tie Rod Puller

  • Wrenches - Metric

  • 18mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
0
0
0
0
Perfect fit for a great price.
Bought a complete front suspension kit for my sons 94 Chevy 1500. Couldn’t have asked for better customer service. Good quality parts for a very good price. I will be for sure buying from 1A Auto again.
June 5, 2018
Purchased
2 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
are the ball joints grease able?
Allen S on May 8, 2018
BEST ANSWER: Hello! Our ball joints come already greased and sealed, so there are no grease fittings. They are built to last, however, and if they fail through intended use, they are covered with a lifetime warranty.

Vehicle Fit

  • 1993-1999 Chevy C1500 Truck Steering & Suspension Kit 14 Piece Set
  • 1993-2000 Chevy C2500 Truck 7200LB GVW Steering & Suspension Kit 14 Piece Set
  • 1993-1999 Chevy Suburban C1500 Steering & Suspension Kit 2 Wheel Drive 14 Piece Set
  • 1995-1999 Chevy Tahoe Steering & Suspension Kit 2 Wheel Drive 14 Piece Set
  • 1993-1999 GMC C1500 Truck Steering & Suspension Kit 14 Piece Set
  • 1993-2000 GMC C2500 Truck 7200LB GVW Steering & Suspension Kit 14 Piece Set
  • 1995-1999 GMC Yukon Steering & Suspension Kit 2 Wheel Drive 14 Piece Set

This part replaces:

  • Hollander 511-00941L
  • Hollander 511-00988BR
  • Hollander 962L
  • Hollander 962R
  • Hollander 963L
  • Hollander 963R
  • Hollander 964L
  • OE # 12361035
  • OE # 12361036
  • OE # 26048561
  • OE # 26051896
  • OE # 7839709
  • OE # 8260485610
  • Dorman 520-129
  • Dorman 520-130
  • Moog ES2004S
  • Moog ES2836RL
  • Moog ES2837RL
  • Moog K5252
  • Moog K620160
  • Moog K620161
  • Moog K6335
  • Moog K6445
  • Moog K6447
Part #: 1ASFK05800

How-to Video:

(08:13 min)