Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a 8 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

    NOTE: After completing the procedure you will need a professional alignment

  1. step : Removing the Wheel (0:47)
    • Loosen the 22mm caps on the hubcap with the vehicle on the ground
    • Pull the hubcap free
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Upper Control Arm (1:10)
    • Mark the tab on the adjustment piece with a marker to mark the alignment
    • Remove the two 10mm bolts holding the brake line and move the brackets
    • Remove the ball joint nut with an 18mm wrench
    • Hit the wheel knuckle and control arm to break them free
    • Remove the 21mm nuts from the upper control arm bracket
    • Jack up the wheel underneath the wheel knuckle
    • Remove the upper control arm nut
    • Remove the bolts and upper control arm bracket
    • Place a nut back on and use an air hammer to knock the bolt out if it won't budge
    • Move the control arm up and down while pulling out
  3. step : Installing the Upper Control Arm (3:52)
    • Put the upper control arm into place and push the 21mm bolts in to hold it
    • Put the brackets on either side and realign them up
    • Angle the control arm down into the wheel knuckle
    • Replace the 18mm ball joint nut
    • Replace the 21mm nuts from the upper control arm bracket
    • Replace and tighten the two 10mm bolts
    • Put a grease gun into place on the end of the control arm and fill it up
  4. step : Reattaching the Wheel (6:00)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 ft/lbs in a crossing or star pattern
    • Reattach the hubcap and tighten the caps

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands

  • Materials, Fluids, and Supplies

  • Marker / Writing Utensil

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 10mm Socket
  • 21mm Socket
  • 22mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 18mm Wrench
  • 21mm wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(07:07 min)

Tools List:

    General Tools

  • Hammer
  • Jack Stands

  • Materials, Fluids, and Supplies

  • Marker / Writing Utensil

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 10mm Socket
  • 21mm Socket
  • 22mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 18mm Wrench
  • 21mm wrench



This part replaces:

  • Moog K80942
  • Moog K80631
  • Moog EV370
  • Moog ES3492T
  • Dorman 520-116
  • Hollander 511-01044
  • Hollander ES3492
  • OE # 15864153, 12475485, 15047200
  • OE # 26079801
  • OE # 26076544

Vehicle Fit

  • 1999-2000 Chevy Silverado 1500 2 Wheel Drive 8 Piece Set Steering & Suspension Kit
  • 2001-2003 Chevy Silverado 1500 2 Wheel Drive excluding Crew Cab 8 Piece Set Steering & Suspension Kit
  • 2004-2006 Chevy Silverado 1500 2 Wheel Drive 6 Lug Wheels 8 Piece Set Steering & Suspension Kit for Models with Rack & Pinion Steering
  • 2007 Chevy Silverado 1500 Classic 2 Wheel Drive 6 Lug Wheels 8 Piece Set Steering & Suspension Kit for Models with Rack & Pinion Steering
  • 1999-2000 GMC Sierra 1500 2 Wheel Drive 8 Piece Set Steering & Suspension Kit
  • 2001-2003 GMC Sierra 1500 2 Wheel Drive excluding Crew Cab 8 Piece Set Steering & Suspension Kit
  • 2004-2006 GMC Sierra 1500 2 Wheel Drive 6 Lug Wheels 8 Piece Set Steering & Suspension Kit for Models with Rack & Pinion Steering
  • 2007 GMC Sierra 1500 Classic 2 Wheel Drive 6 Lug Wheels 8 Piece Set Steering & Suspension Kit for Models with Rack & Pinion Steering
Part #: 1ASFK05164

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More