Specifications:

  • Brand New Steering & Suspension Kit
  • Comes as a 10 Piece Kit
    • Fits LH (Driver Side) & RH (Passenger Side)
  • Direct replacements
  • Built to strict quality control standards

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:44)
    • Loosen the lug nut covers with a 22mm socket
    • Pry off the center cap by hand
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:10)
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • Make note of this measurement
    • Loosen the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Remove the 18mm nut from the outer tie rod end
    • Strike the steering knuckle with a hammer to loosen the outer tie rod
    • Pull the outer tie rod out of the steering knuckle
    • Hold the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Twist off the outer tie rod by hand
  3. step : Installing the New Outer Tie Rod (2:08)
    • Attach the grease fitting to the new outer tie rod
    • Tighten the grease fitting with a 7mm socket and ratchet
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the 18mm castle nut onto the outer tie rod
    • Push the cotter pin through the castle nut
    • Twist the cotter pin into place with needle nose pliers
    • Fill the tie rod with grease, using a grease gun
    • Measure the distance from the boot of the inner tie rod to the edge of the outer tie rod
    • This should be the same as the measurement noted in Step 2
    • Tighten the nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
  4. step : Reattaching the Wheel (3:33)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the center cap
    • Tighten the lug nut covers with a 22mm socket

Tools needed for replacement:

    General Tools

  • Hammer

  • Materials, Fluids, and Supplies

  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Adjustable Wrench
  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Specialty Tools

  • Grease Gun

3.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
0
0
1
0
0
Grease zerKS broke on 2 ball joints didn't hardly even tighten them down. Not impressed
March 17, 2017
Purchased
11 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions Browse 2 questions and 5 answers
Do the outer tie rods in the kit need greased? If so how? There isn't a zero port on them.
Nic P on May 18, 2017
BEST ANSWER: We have multiple manufacturers make these parts for us, and typically they are sealed units with no zerks.
Just want to make sure that this will fit my 2005 Chevy Silverado 1500 4wheel drive Z71 crew cab 5.3l?
Chadrico on Aug 21, 2016
BEST ANSWER: 1999-2006 Chevy Silverado 1500 4 Wheel Drive 10 Piece Set Steering & Suspension Kit with (2) Front Upper Ball Joints (2) Front Lower Ball Joints (2) Front Inner Tie Rods (2) Front Outer Tie Rods & (2) Front Sway Bar Links

Yes, according to the information you supplied, the part you���re looking at will be correct for your vehicle. If you have any other questions or would like to place an order with one of our customer service representatives, please feel free to give us a call.

How-to Video:

(04:28 min)

Tools List:

    General Tools

  • Hammer

  • Materials, Fluids, and Supplies

  • Bearing Grease

  • Pliers, Cutters & misc Wrenches

  • Adjustable Wrench
  • Needle nose pliers

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Specialty Tools

  • Grease Gun



This part replaces:

  • OE # 15295861, 26059210
  • OE # 12475478
  • OE # 19149617
  • OE # 12475486
  • Moog ES3493T
  • Moog K6541
  • Moog K6540
  • Moog K80631
  • Moog ES3488

Vehicle Fit

  • 2002-2006 Cadillac Escalade 10 Piece Set Steering & Suspension Kit
  • 2003-2006 Cadillac Escalade ESV 10 Piece Set Steering & Suspension Kit
  • 2002-2006 Cadillac Escalade EXT 10 Piece Set Steering & Suspension Kit
  • 2002-2006 Chevy Avalanche 1500 10 Piece Set Steering & Suspension Kit
  • 1999-2006 Chevy Silverado 1500 4 Wheel Drive 10 Piece Set Steering & Suspension Kit
  • 2007 Chevy Silverado 1500 Classic 4 Wheel Drive 10 Piece Set Steering & Suspension Kit
  • 2000-2006 Chevy Suburban 1500 10 Piece Set Steering & Suspension Kit
  • 2000 Chevy Tahoe 10 Piece Set Steering & Suspension Kit excluding Z71 Models
  • 2001-2006 Chevy Tahoe 10 Piece Set Steering & Suspension Kit
  • 1999-2006 GMC Sierra 1500 4 Wheel Drive 10 Piece Set Steering & Suspension Kit
  • 2007 GMC Sierra 1500 Classic 4 Wheel Drive 10 Piece Set Steering & Suspension Kit
  • 2000 GMC Yukon 10 Piece Set Steering & Suspension Kit excluding Denali Models
  • 2001-2006 GMC Yukon 10 Piece Set Steering & Suspension Kit
  • 2000-2006 GMC Yukon XL 1500 10 Piece Set Steering & Suspension Kit
Part #: 1ASFK02505

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More