Specifications:

  • Front Suspension Kit
  • Comes as a Set of 8
    • Fits LH (Driver Side) & RH (Passenger Side) Front
  • Direct replacements
  • Built to strict quality control standards

 

Our steering and suspension components come pre-greased, sealed for long life, and do not require the extra maintenance typically required by greasable versions.

Direct Fit

Application-specific, with no modifications required.

Rigorously Tested

Made from higher quality materials than the competition. Built to have a longer life in any environment or road conditions.

State of the Art Manufacturing

By the same factories that the OEMs use.

Prepackaged for Your Convenience

Carefully assembled to include all of the parts you need, saving time and money.

Part Details

  • Kit Includes: (2) Front Outer Tie Rods
  • Kit Includes: (2) Front Lower Control Arms with Ball Joints
  • Kit Includes: (2) Front Sway Bar Links
  • Kit Includes: (2) Front Inner Tie Rods
  • Quantity: 8 Piece Set

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

  1. step : Removing the Wheel (0:58)
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Stabilizer Link (1:17)
    • Hold the lower sway bar link stud with a 14mm wrench
    • Remove the lower nut from the sway bar link with a 15mm socket and ratchet
    • Hold the upper sway bar link stud with a 14mm wrench
    • Remove the upper nut from the sway bar link with a 15mm socket and ratchet
    • Pull off the stabilizer link
  3. step : Installing the Stabilizer Link (2:54)
    • Hold the lower sway bar link stud with a 14mm wrench
    • Tighten the lower 15mm nut onto the stabilizer link
    • Hold the upper sway bar link stud with a 14mm wrench
    • Tighten the upper 15mm nut onto the stabilizer link
  4. step : Reattaching the Wheel (4:05)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Floor Jack

  • Ratchets & Related

  • Torque Wrench
  • A Piece of Pipe (for leverage)
  • 1/2 Inch Breaker Bar
  • Ratchet

  • Sockets - Metric

  • 15mm Socket
  • 21mm Socket

  • Wrenches - Metric

  • 14mm Wrench

3.3 / 5.0
3 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
1
0
0
1
Overal, excellent fit and good part for the price!
The price for the amount of parts included in the kit is great, and everything fit and is operating great! My only complaints (and the only reason I did not give it five stars) is that some of the replacement bolts are not the same size as either the original factory or what they say in the video. Because of this I had to stop in the middle of the repair to go buy an additional socket size that I shouldn't have needed. The other small issue I noticed was that after installing the castle nut for the ball joint of the lower control arms, and torquing to specs indicated in the video, the cotter pin hole was above the slots of the castle nut so that it is not going to prevent the nut from reversing. It seems that the hole for the hotter pin was positioned too high. The parts are made in China and other countries "as available" so I'm not so sure about the quality control and uniformity. But, it all installed and is functional and saved me a lot of money taking it somewhere so overall I am satisfied.
June 16, 2018
Purchased
2 months ago
2001 Maxima 3.0
With the help of the 1A Auto video this job was simple and took less time then I expected. The parts are well built and with the warranty you have no worries.
July 31, 2017
Purchased
1 year ago
Irregular part
The left control arm did not fit. I had to purchase a MOOG
control arm from Autozone which cost the entire purchase I had originally paid for in the 1A Auto parts. I thought I had found the perfect auto parts site particularly since women are always taken advantage of in auto parts stores, however due to this experience I probably won't buy auto parts from 1A Auto either.
March 17, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 5 answers
Does inner tie rods have bellows?
Will A on Sep 6, 2016
BEST ANSWER: Im not sure but I do know that the kit contained everything I needed to replace my entire front-end suspension. Hopes this helps.

Vehicle Fit

Year Make Model Description
2000-2001Infiniti I30 Infiniti I30 8 Piece Set Steering & Suspension Kit
2002-2004Infiniti I35 Infiniti I35 8 Piece Set Steering & Suspension Kit
2000-2002Nissan Maxima Nissan Maxima 8 Piece Set Steering & Suspension Kit

This part replaces:

  • OE # 485215Y085
  • OE # 485215Y025
  • OE # 545002Y412
  • OE # 545012Y412
  • OE # 546182Y000
  • OE # 546682Y000
  • OE # 485200M085
  • Dorman 520-517
  • Dorman 520-518
  • Hollander 512-58322L
  • Hollander 512-58521R
  • Moog K620355
  • Moog K620354
  • Moog ES3438
  • Moog K90432
  • Moog K90431
  • Moog EV458
  • OE # 485200M025, 485200M085
  • OE # 48521-5Y025, 48521-5Y085
  • OE # 54668-2Y000
  • OE # 54618-2Y000
  • OE # 54501-2Y412
  • OE # 54500-2Y412
Part #: 1ASFK00999


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(04:45 min)