Replaces

Saab 9-2X Subaru Impreza WRX Ignition Coil Pair - 1AERK00263

The ignition coil is a crucial part of your ignition system. It's function is to convert the 12 volt power of your vehicle's electrical system in to 35,000 or more volts. This produces a high intensity spark at the spark plug which then ignites the fuel in the cylinder. Coils in general will wear out over time. This will cause a misfire condition.

Specifications:

  • Brand New Ignition Coil PAIR
  • Replaces dealer part numbers: 22433-AA451, 22433-AA550, 22433-AA551, 32005953, 32009782, 22433AA451, 22433AA550, 22433AA551
  • Built to strict quality control standard
  • Direct replacement
  • 100% factory tested

This coil is for a distributorless application. Sold as a PAIR. Replace individually as needed.

 

 

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

 

Direct Fit Replacement

Guaranteed to fit and function properly for your specific application.

Optimum Performance

Meets or exceeds requirements of the vehicle. Provides the correct primary and secondary resistance, voltage output, and spark energy needed to restore original operating condition.

Premium Quality

Manufactured with quality materials to meet highest quality control standards in the industry.

Part Details

  • Quantity: Pair

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Battery (0:24)
    • Disconnect the negative terminal with a 10mm wrench
    • Disconnect the positive terminal with a 10mm wrench
    • Loosen the 10mm bolts from the bracket
    • Remove the bracket and hold down
    • Lift the battery up and out
    • Remove the plastic tray
  2. step : Removing the Windshield Washer Bottle (3:06)
    • Remove the two 10mm bolts atop the washer bottle
    • Lift the bottle up off its stud
    • Disconnect the washer pump connector
    • Remove the hose from the pump
  3. step : Removing the Driver Side Ignition Coil Packs (4:48)
    • Carefully press the electrical connector lock
    • Disconnect the ignition coil electrical connector
    • Remove the 10mm bolt from the connector
    • Remove the ignition coil
  4. step : Removing the Driver Side Spark Plugs (7:22)
    • Loosen the spark plug with a 5/8 spark plug socket and extension
    • Remove the spark plug
  5. step : Installing the Driver Side Spark Plugs (8:42)
    • Press the spark plug into the spark plug socket
    • Gently hand-tighten the spark plug
    • Torque the spark plug to 15 foot-pounds
  6. step : Installing the Driver Side Ignition Coil Packs (10:41)
    • Insert the coil into place
    • Tighten the 10mm bolt to the ignition coil
    • Connect the electrical connector
  7. step : Removing the Airbox (14:40)
    • Remove the two 10mm bolts from the air duct
    • Lift the air duct up and out
    • Disconnect the mass air flow meter
    • Pop the coolant lines out of the clips
    • Pop the throttle cable out of the intake tube
    • Remove the 8mm bolt from the hose clamp
    • Unlatch the airbox cover
    • Remove the cover
    • Remove the air filter
    • Remove the 10mm bolts from the airbox
    • Remove the airbox
  8. step : Removing the Passenger Side Ignition Coil Packs (17:40)
    • Carefully press the electrical connector lock
    • Disconnect the ignition coil electrical connector
    • Remove the 10mm bolt from the connector
    • Remove the ignition coil
  9. step : Removing the Passenger Side Spark Plugs (19:13)
    • Loosen the spark plug with a 5/8 spark plug socket and extension
    • Remove the spark plug
  10. step : Installing the Passenger Side Spark Plugs (19:55)
    • Press the spark plug into the spark plug socket
    • Gently hand-tighten the spark plug
    • Torque the spark plug to 15 foot-pounds
  11. step : Installing the Passenger Side Ignition Coil Packs (21:00)
    • Insert the coil into place
    • Tighten the 10mm bolt to the ignition coil
    • Connect the electrical connector
  12. step : Installing the Airbox (27:22)
    • Insert the airbox into place
    • Tighten the 10mm bolts to the airbox
    • Insert the air filter
    • Press the cover on
    • Latch the airbox cover
    • Tighten the 8mm bolt to the hose clamp
    • Pop the throttle cable into the intake tube
    • Pop the coolant lines into the clips
    • Connect the mass air flow meter
    • Press the air duct on
    • Tighten the two 10mm bolts to the air duct
  13. step : Installing the Windshield Washer Bottle (30:40)
    • Connect the hose to the pump
    • Connect the connector
    • Insert the washer bottle into place
    • Tighten the two 10mm bolts to the washer bottle
    • Refill the bottle with the appropriate fluid
  14. step : Installing the Battery (32:11)
    • Insert the plastic tray into place
    • Place the battery on the tray
    • Insert the bracket and hold down
    • Tighten the 10mm bolts to the bracket
    • Connect the negative terminal with a 10mm wrench
    • Connect the positive terminal with a 10mm wrench

Tools needed for replacement:

    General Tools

  • Pick

  • Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Socket Extensions
  • Torque Wrench
  • Ratchet

  • Sockets - Metric

  • 12mm Socket
  • 8mm Socket
  • 10mm Socket

  • Sockets - SAE

  • 5/8 Inch Spark Plug Socket

  • Wrenches - Metric

  • 8mm Wrench
  • 10mm Wrench
  • 12mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2005 Saab 9-2X Ignition Coil Pair H4 2.0L Turbo
  • 2004-2005 Subaru Impreza WRX Ignition Coil Pair H4 2.0L Turbo
Part #: 1AERK00263

How-to Video:

(34:27 min)