Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

This power window motor is just what you need to get your vehicle in good shape again! If your window regulator is good, but the motor is burned out, then this is the part for you.

Specifications:

  • Fits either LH (Driver Side) or RH (Passenger Side) FRONT or REAR as listed by application
  • Brand New
    • No core charge
  • Replaces dealer part numbers: 4624624, R4624624
  • Direct replacement
  • Built to strict quality control standards
NOTE: Due to dealer changes, part numbers may be reversed on some models. Please match your motor to the picture shown before ordering.

This window motor makes a great replacement and has good cost savings over a dealer unit.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (1:14)
    • Use a flat blade screwdriver to pry off the bezel inside the door pull
    • Use a flat blade screwdriver to pry off the bezel inside the door handle
    • Remove the Phillips head screw inside the door handle
    • Remove the Phillips head screw inside the door pull
    • Remove the three Phillips head screws alongside the bottom of the door panel
    • Remove the Phillips head screw at the back of the door panel
    • Pull off the mirror base trim
    • With a putty knife pry off the door panel
    • Disconnect the door lock wiring harness
    • Disconnect the latch rod from the door handle
    • Disconnect the power window switch wiring harness
    • If any pins remain in the door, remove them with needle nose pliers
    • Reinstall those pins into the door panel
  2. step : Removing the Window Regulator (3:34)
    • Carefully pull back the water shield, avoiding tearing it
    • Remove the six 10mm nuts that hold the regulator to the door
    • Pull the window down partially by hand
    • Loosen the two 10mm nuts on the window track
    • Remove the window from the window track
    • Pull the window up by hand
    • Pull the window regulator partially out
    • Disconnect the window motor wiring harness
  3. step : Detaching the Window Motor from the Window Regulator (6:46)
    • Remove the three T25 Torx screws that hold the motor to the regulator
    • Detach the motor from the regulator
  4. step : Attaching the New Motor to the Regulator (7:24)
    • Line up the motor and regulator gears
    • Push the motor into place
    • Start the three screws by hand
    • Tighten the three T25 Torx screws
  5. step : Reattaching the Window Regulator (8:06)
    • Connect the window motor to its wiring harness
    • Connect the window switch to its wiring harness
    • Turn the regulator down slightly, using the window switch
    • Insert the regulator into the door
    • Put the regulator into place
    • Start all the nuts and bolts by hand
    • Tighten all the nuts and bolts
    • Move the regulator into place with the window switch
    • Disconnect the wiring harness from the window switch
    • Slide the window onto the window track
    • Tighten the 10mm nuts on the window track
    • Carefully put the water shield back into place
  6. step : Reinstalling the Door Panel (11:11)
    • Reconnect the wiring harness to the window switch
    • Check that the window regulator and motor function properly
    • Reconnect the door lock switch
    • Clip the latch rod to the door handle
    • Slide the door panel into place
    • Push the door panel locating tab into its hole
    • Push the pins in
    • Insert the Phillips screw into the door pull
    • Insert the Phillips screw into the door handle
    • Insert the three Phillips screws along the bottom of the door panel
    • Insert the Phillips screw at the back of the door panel
    • Push the mirror base trim back into place
    • Put the bezel back into the door handle
    • Put the bezel back into the door pull

Tools needed for replacement:

    General Tools

  • Flashlight
  • Putty Knife

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Specialty Tools

  • Door Panel Removal Tool

  • Torx Drivers & Sockets

  • T30 Torx Driver

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
1995-1996Chrysler Cirrus Chrysler Cirrus Power Window Motor for Models with with 7 or 9 Tooth Window Motor Rear Driver Side Dorman 742-311
1995-1996Chrysler Cirrus Chrysler Cirrus for Models with with 9 Tooth Window Motor Power Window Motor Front Passenger Side Dorman 742-311
1993-1997Chrysler Concorde Chrysler Concorde Power Window Motor Rear Passenger Side Dorman 742-311
1993-1997Chrysler Concorde Chrysler Concorde Power Window Motor Front Passenger Side Dorman 742-311
1994-1996Chrysler New Yorker Chrysler New Yorker Power Window Motor Rear Passenger Side Dorman 742-311
1994-1996Chrysler New Yorker Chrysler New Yorker Power Window Motor Front Passenger Side Dorman 742-311
1990-1994Dodge B150 Dodge B150 Power Window Motor Front Driver Side Dorman 742-311
1995-1998Dodge B1500 Dodge B1500 Power Window Motor Front Driver Side Dorman 742-311
1990-1994Dodge B250 Dodge B250 Power Window Motor Front Driver Side Dorman 742-311
1995-1998Dodge B2500 Dodge B2500 Power Window Motor Front Driver Side Dorman 742-311
1990-1994Dodge B350 Dodge B350 Power Window Motor Front Driver Side Dorman 742-311
1995-1998Dodge B3500 Dodge B3500 Power Window Motor Front Driver Side Dorman 742-311
1995-1996Dodge Dakota Dodge Dakota Power Window Motor Front Driver Side Dorman 742-311
1993-1997Dodge Intrepid Dodge Intrepid Power Window Motor Rear Passenger Side Dorman 742-311
1993-1997Dodge Intrepid Dodge Intrepid Power Window Motor Front Passenger Side Dorman 742-311
1992-1995Dodge Spirit Dodge Spirit Power Window Motor Front Passenger Side Dorman 742-311
1995-1996Dodge Stratus Dodge Stratus Power Window Motor for Models with with 7 or 9 Tooth Window Motor Rear Driver Side Dorman 742-311
1995-1996Dodge Stratus Dodge Stratus for Models with with 9 Tooth Window Motor Power Window Motor Front Passenger Side Dorman 742-311
1993-1997Eagle Vision Eagle Vision Power Window Motor Rear Passenger Side Dorman 742-311
1993-1997Eagle Vision Eagle Vision Power Window Motor Front Passenger Side Dorman 742-311
1992-1995Plymouth Acclaim Plymouth Acclaim Power Window Motor Front Passenger Side Dorman 742-311
Part #: 1AWPM00171

Out of Stock

Dorman
Brand #: 742-311

How-to Video:

(13:35 min)