Replaces
O2 Oxygen Sensor - 1AEOS00060
1AEOS00060Specifications:
- Direct Fit
- Correct Connector No cutting or splicing
- Correct wire length (10.75")
- Upstream Sensor as listed per applications
- Air / Fuel ratio (wide range) sensor
- Heated
- 4 wire configuration
- Built and tested to strict quality control standards
Note: For clarification purposes:
- Upstream location is between the catalytic converter and the engine
- Downstream location is between the catalytic converter and the tailpipe
If you have a bad O2 sensor causing your vehicle to run poorly or fail an emission test then this is the part for you.
Our electrical and electronic parts are subject to strict quality control testing. Once the item has been installed or plugged in, it is no longer eligible for a refund. The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed
Note: You may be required to reset the vehicle’s computer after installation of this part.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Identifying your Oxygen Sensors (0:57)
- Upstream oxygen sensors are located in between the engine and the catalytic converter
- Downstream oxygen sensors are located in the catalytic converter or farther away from the engine than the catalytic converter
- Locate your vehicle's firing order diagram
- The bank that contains cylinder one is bank one
- The bank that does not contain cylinder one is bank two, even if it does not contain cylinder two
Tools needed for replacement:
- No Tools Needed
1A - No Tools Needed
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
- Reply
- Inaccurate
- Alex P Staff on Dec 11, 2017
Vehicle Fit
- 2002-2003 Lexus ES300 V6 3.0L Rear Bank Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
- 2004-2006 Lexus RX330 V6 3.3L (Japan Built Models (1st VIN Digit J)) Rear Bank Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
- 2002-2006 Toyota Camry V6 3.0L Rear Bank Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
- 2004-2007 Toyota Highlander V6 3.3L Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
- 2004-2006 Toyota Sienna V6 3.3L Rear Bank Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
- 2007-2009 Toyota Sienna V6 3.5L Rear Bank Upstream (Air / Fuel Ratio) O2 Oxygen Sensor
This part replaces:
- OE # 8946760010, 8946748060, 8946733050
- Standard Motor Products SG757