O2 Oxygen Sensor - 1AEOS00005

This Oxygen O2 Sensor is a new, aftermarket replacement part that has the following specifications:

• Four wire O2 sensor
• Direct Fit Correct Connector No cutting or splicing
• Correct wire length (35.4 Inches)
• Correct replacement for Downstream or Rear Oxygen Sensor
• Replaces dealer part numbers: 36532-P0A-A01, 065500-2560, 36532P0AA01, 0655002560
• Built and tested to strict quality control standards
• Some applications use (2) of the same Oxygen Sensors Upstream

Note: For clarification purposes:

• Upstream location is between the catalytic converter and the engine
• Downstream location is between the catalytic converter and the tailpipe

A direct replacement. If you have a bad O2 sensor causing your vehicle to idle poorly or fail an emission test then this is the part for you.

Install note:

You may be required to reset the vehicle computer after installation of this part.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Identifying your Oxygen Sensors (0:57)

• Upstream oxygen sensors are located in between the engine and the catalytic converter
• Downstream oxygen sensors are located in the catalytic converter or farther away from the engine than the catalytic converter
• Locate your vehicle's firing order diagram
• The bank that contains cylinder one is bank one
• The bank that does not contain cylinder one is bank two, even if it does not contain cylinder two