Nissan Altima Maxima Heater Blower Motor with Fan Cage - 1AHCX00326

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

This heater blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order!


  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Replaces dealer part number: 27225-7Y000, 272257Y000
  • Direct replacement
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality control testing. Please ensure proper diagnosis of this item before purchasing as the item cannot be returned once installed or plugged in.

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Glove Box (0:21)
    • Press the two hinge pins toward the center of the box to unlock the hinges
    • Unhook the glove box from the pins
    • Unclip the tether
  2. step : Removing the Dashboard Trim (1:20)
    • Remove the four Phillips screws along the top
    • Remove the two Phillips screws along the bottom
    • Pop out the rocker panel side trims on either side
    • Pry out the trim from the clips
    • Turn the bulb counterclockwise to disconnect it from the trim
    • Disconnect the trunk switch
    • Remove the trim
  3. step : Removing the Blower Motor (3:01)
    • Disconnect the electrical connectors
    • Remove the Phillips screws from the blower motor
    • Press the tabs around the assembly
    • Pry the motor down
    • Unclip the harness from the motor
    • Remove the motor
  4. step : Preparing the Blower Motor (5:42)
    • Transfer the flex hose from the blower motor over
    • Transfer the clip over to the new blower motor
    • Remove the Phillips screws from the resistor
    • Insert the resistor to the new motor
    • Tighten the Phillips screws to the resistor
    • Transfer the protective rubber cap
  5. step : Installing the Blower Motor (7:00)
    • Clip the blower motor into place
    • Clip the harness to the motor
    • Tighten the Phillips screws to the blower motor
    • Connect the electrical connectors
  6. step : Installing the Dashboard Trim (10:15)
    • Turn the light clockwise into the glove box
    • Connect the switch connector
    • Line up the clips on the dashboard trim with the slots on the dash
    • Press the trim into the dash so it clicks
    • Press on the rocker panel side trims
    • Tighten the six Phillips screws to the trim
  7. step : Installing the Glove Box (12:15)
    • Connect the tether to the glove box
    • Slide the glove box to the hinge
    • Press the two hinge pins into their slots

Tools needed for replacement:

    Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

5.00/ 5.0
2 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Great value
This part was a perfect fit for my car at a great price. Shipping was pretty quick even around Christmas time.
January 9, 2018
fast and good $
Shipping was fast and it plugged right in and is kicking heat and air out perfectly.
March 12, 2018
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Hello,have a 2004 max.starts and idle good ,will run at 35mph start shutting down whats the reason?
Gary B September 19, 2017
There could be mutliple reasons that this is occuring. We recommend having it diagnosed by a reputable shop to ensure a first time successful replacement. It could be wiring to the motor overheating, or wiring being loose.
Alex P September 19, 2017
Year Make Model Description
2005-2006Nissan Altima Nissan Altima Heater Blower Motor with Fan Cage with Manual Temperature Control
2004-2008Nissan Maxima Nissan Maxima Heater Blower Motor with Fan Cage
Only 1 left in stock
Part #: 1AHCX00326

Order must be placed by 4pm ET
Delivery options for:

Estimated Arrival Cost

Deliveries made to PO Boxes and FPO may take longer. See our Shipping & Delivery for more information.

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(14:09 min)