Mirror - 1AMRE01922

Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

Part Details

  • Mirror Signal Type:   Signal & Clearance Light
  • Mirror Operation:   Power
  • Mirror Color / Finish:   Textured Black
  • Mirror Heating Type:   Heated

This replacement mirror is just what you need to get your Dodge Ram truck in good looking form again!

This mirror features the following specifications:

  • LH (Driver Side)
  • Power
  • Heated
  • Signal
  • Clearance Light
  • Folding - Manual
  • Textured black grained finish
  • Replaces dealer part number: 68026559AD
  • Direct replacement
  • Built to strict quality control standards
  • No Memory Function
  • No Power Fold

This mirror makes a great replacement and has good cost savings over a dealer mirror.

Special Note:

  • Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Beginning the Repair (0:00)
    • This is Part 1 of a two part video
    • Please consult Part 2 for further instructions
    • Perform the steps outlined in Part 2
  2. step : Removing the Door Panel (1:13)
    • Remove the screws in the door handle with a Phillips screwdriver or a 7mm socket and ratchet
    • Remove the door handle bezel
    • Remove the T20 clips along the edge of the door panel
    • Pull the door panel out
    • Pry up the master switch panel
    • Disconnect the switch wiring harnesses
    • Lift the door panel up and off
  3. step : Removing the Side View Mirrors (2:15)
    • Disconnect the mirror wiring harness
    • Remove the three 10mm nuts from the mirror
    • Remove the mirror
  4. step : Installing the New Driver Side View Towing Mirror (2:49)
    • Insert the towing mirror into place
    • Tighten the three 10mm nuts to the mirror
    • Connect the mirror wiring harness
  5. step : Removing the Driver Side Dash Panels (4:03)
    • Remove the two Phillips screws from the lower dash panel beneath the steering wheel
    • Remove the lower dash panel
    • Remove the side dash panel
    • Remove the kick panel
    • Remove the two T20 Torx screws from the dead panel
    • Remove the dead panel
  6. step : Preparing the Folding Option Switch (5:24)
    • Disconnect the new folding switch connecter from its switch
    • Drill a hole in the dead panel with a 1/4" drill bit
    • Push the connecter into the dead panel to make sure it fits
  7. step : Connecting the Ground to a Ground Bolt (5:55)
    • Mark the each mirror wire to identify them
    • Feed the wires through the dead panel's positioning space
    • Wire-tie the connector to the dead panel slot
    • Loosen the ground bolt with a 10mm wrench
    • Insert the wiring harness ground into place
    • Tighten the 10mm ground bolt
  8. step : Connecting the Folding Option Wire to a Power Source (7:08)
    • Find the switched 12 volt power source wire (Blue wire with a purple stripe)
    • Insert and inline wiretap to the 12 volt wire
    • Hold the wiretap in place with pliers
    • Insert the mirror wire into the wiretap
    • Squeeze the wiretap tightly to secure the mirror wire
  9. step : Preparing the Passenger Side for the Folding Option Wire (8:44)
    • Pull straight out on the sides of the lower passenger dash panel to remove it
    • Open the glove box and pull the sides to remove it
    • Pull back firmly on the kick panel and pull up on the carpet trim to remove it
    • Remove the two T20 Torx screws from the door
    • Pry off the rubber boot and disconnect the wiring harness
    • Feed the rubber boot out through the door
    • Remove the tape and disconnect the plastic duct from the rubber boot
  10. step : Routing the Power Folding Option Wire to the Passenger Side (11:29)
    • Rout the wire through the center dash to the passenger door
    • Insert the behind the weatherstrip
    • Tape the wire to a screwdriver and pull it through the rubber boot
    • Connect the passenger side wire
  11. step : Testing the Power Folding Option (13:21)
    • Plug in the mirror folding switch
    • Turn on the vehicle
    • Press the switch to fold the mirrors

Tools needed for replacement:

    Drills, Drill Bits & Related

  • Drill
  • 1/2 Inch Drill Bit

  • Materials, Fluids, and Supplies

  • Electrical Tape
  • Duct Tape
  • Wire Ties

  • Pliers, Cutters & misc Wrenches

  • Needle nose pliers

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 7mm Socket
  • 10mm Socket

  • Torx Drivers & Sockets

  • T20 Torx Driver

5.00/ 5.0
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Very Satisfied
I recently purchased a replacement drivers side mirror for our 2011 Ram 2500 truck after a oak tree carelessly moved into the the path of the truck mirror while backing up on the ranch. The replacement mirror arriived quickly, was a perfect match, and installation took about 15 minutes just as the installation video demonstrated. We also saved substantial cost and time from the dealer service department. Sadly, Im gonna miss that tree!
March 28, 2017
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2009-2010Dodge Ram 1500 Truck Dodge Ram 1500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
2010Dodge Ram 2500 Truck Dodge Ram 2500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
2010Dodge Ram 3500 Truck Dodge Ram 3500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
2011Ram 1500 Truck Ram 1500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
2011Ram 2500 Truck Ram 2500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
2011Ram 3500 Truck Ram 3500 Truck Power Heated Signal & Clearance Light Textured Black Mirror Driver Side
Part #: 1AMRE01922

Out of Stock

How-to Video:

(14:21 min)