Replaces

Jeep Grand Cherokee Wrangler Crankshaft Position Sensor - 1AECS00014

This replacement Crankshaft Position Sensor is just what you need to get your vehicle in good running condition again!

A bad or malfunctioning crank sensor will often cause a service engine light error code, and or cause a no start condition, or rough running due to inaccurate ignition and fuel timing.

This Crank Sensor features:

  • Built to strict quality control standards
  • Direct replacement
  • Replaces dealer part number: 56026884
  • 100% factory tested

Your Engine size can usually be found on a white sticker in the engine compartment near the radiator. If needed, your VIN code is the 8th digit of your vehicles Vehicle Identification number. The VIN can be found on the bottom drivers side corner of the windshield and on your registration. Some refer to the VIN code as the Serial Number.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Crankcase position sensor
Good video, installed with no problems, allowed my daughter to install with my help.
June 27, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 2 answers
Does it come with spacer?
Kevin B on May 3, 2016
BEST ANSWER: Kevin,
The sensor did not come with a spacer. For my 1995 Jeep, a spacer was not required.

Vehicle Fit

  • 1993-1996 Jeep Grand Cherokee Crankshaft Position Sensor L6 4.0L
  • 1993-1995 Jeep Wrangler Crankshaft Position Sensor L6 4.0L with Automatic Transmission

This part replaces:

  • OE # 56026884
  • OE # 56027280
  • Standard Motor Products PC42T
Part #: 1AECS00014