Warranty & Shipping
How-To & Tools
Product Reviews
Vehicle Fit

This replacement tail light is just what you need to get your Jeep Grand Cherokee in good looking form again!


  • LH (Driver Side)
  • Direct bolt on
  • Replaces dealer part number: 5101897AB
  • Direct replacement
  • Injection molded plastic
  • Department of Transportation (DOT) and Society of Automotive Engineers (SAE) approved
  • Fits Grand Cherokee vehicles 1999 thru production date of 10/31/02
  • Bulbs & bulb sockets are not included

*Note: For 2002 models you can find the production date of your vehicle on either the outer edge of the driver's front door or on the latch piller that the door closes on.

We have noticed that there are many inferior quality Tail lights on the market. We have researched other tail light manufacturers and are only selling what we believe to be the highest quality, best fitting, aftermarket tail lights available. So don't be fooled by cheaper made imitation Tail lights. Go with superior quality!

This Jeep Grand Cherokee tail light makes a great replacement and has good cost savings over a dealer unit.


Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Tail Light (0:36)
    • Remove the two Phillips screws from the tail light.
    • Pull the taillight forward.
    • Disconnect the connector on the back of the light.
  2. step : Changing the Bulbs (1:12)
    • Turn the caps to unlock and pull the bulbs free.
  3. step : Replacing the Tail Light (1:46)
    • Reconnect the harness to the light.
    • Line the taillight up and push it into place.
    • Replace the two Phillips screws.

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

5.00/ 5.0
2 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Perfect match. The dealer wanted $160 Canadian plus tax. After shipping and duties I still saved over $75! Will buy from 1A again.
November 2, 2009
2000 Jeep Grand Cherokee Tail Light
After receiving the tail light, I reviewed the tail light installation video from 1A Auto and installed the new tail light with no problems. Everything fit and worked perfectly, I will purchase any future parts I might need from 1A Auto.
September 1, 2017
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
Does this come with the 2 screws that are mentioned? I believe Im missing one. If it doesnt, what do you think my best bet is to get another screw thatll work?
Brandy D September 10, 2015
2001 jeep grand cherokee brake light does not on drivers side when light are on?
David E January 9, 2016
Had the issue. Replaced the taillight and fixed the problem. But I would also replace the sockets for the bulbs. I did not get new sockets and had to replace those about 6 months later.
Douglas W January 10, 2016
Im not 100% sure what your question is, but I think you are trying to say when you turn the head lights on the brake light no longer works when you press the peddle. I had this problem as well, I replaced the bulb sockets, there are 3 in each light assembly, I also used dialectic grease on all the connections to make sure a good water tight connection was made and it fixed the problem.
Michael B January 10, 2016
I had a bunch of issues with my taillights on my 2002 Jeep Grand Cherokee. The lights were cutting in and out and it was a bad connection on the bulb housing. A few people suggest lifting up the metal tabs for a better connection, using some gel for better electrical connectivity, or replacing the housing all together. I ended up burning a fuse out while I was messing around with my bulb housings so after replacing the taillight and two of my bulb housings I replaced the fuse and everything worked.
Thomas W January 10, 2016
Ronald W. R January 11, 2016
2001 jeep grand cherokee brake light on drivers side does not work when headlights light are on?
David E January 9, 2016
I replaced the taillight assembly and put in new light sockets and all my lights worked properly after doing so,,
Brian G January 10, 2016
Check the bulb.
Barry B March 9, 2017
Year Make Model Description
1999-2002Jeep Grand Cherokee Jeep Grand Cherokee Tail Light Driver Side
2003Jeep Grand Cherokee Jeep Grand Cherokee (Built Before 11/02 Production Date) Tail Light Driver Side
Part #: 1ALTL00124

Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(03:17 min)