1ADHI00648-Interior Door Handle
Replaces
Interior Door Handle - 1ADHI00648
1ADHI00648
This door handle is just what you need to get your vehicle in good looking form again!
Specifications:
- Fits LH (Driver Side) FRONT or REAR
- Replaces dealer part number: 3W7Z-5421819-AAB, 3W7Z5421819AAB
- Flint Gray Finish
- Direct replacement
- Built to strict quality control standards
This door handle is a great replacement and has good cost savings over the dealer unit.
Special Note:
- This new handle is made to the original color shade. Due to vehicle age and fading from the sun, our new handles may not match your existing handle or bezel exactly. If you are looking for an exact match, we recommend replacing handles in pairs or sets.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Removing the Door Panel (0:35)
- Pry up the window switch panel with a flat blade screwdriver
- Disconnect the wiring harnesses
- Pry off the trim piece inside the door handle with a flat blade screwdriver
- Remove the T30 bolt from the door handle
- Remove the three 7mm bolts from the door panel
- Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
- Remove the 7mm bolt from the door pull
- Lift the door panel up and off
-
step : Removing the Inside Door Handle (1:51)
- Push in the four clips on the back of the door handle
- Remove the door handle from the door panel
-
step : Installing the New Inside Door Handle (1:56)
- Push the door handle into place
-
step : Installing the Door Panel (2:00)
- Lift the door panel into place
- Push in the door panel clips
- Insert and tighten the three 7mm bolts on the door panel
- Insert and tighten the 7mm bolt in the door pull
- Insert and tighten the T30 bolt in the door handle
- Insert the trim piece inside the door handle
- Push on the trim piece at the top front corner of the door panel
- Connect the wiring harnesses to the switch panel
- Push the switch panel into place
Tools needed for replacement:
- Ratchet
- Flat Blade Screwdriver
- 7mm Socket
- T30 Torx Driver
Ratchets & Related
Screwdrivers & Related
Sockets - Metric
Torx Drivers & Sockets
Start typing your question and we'll check if it was already asked and answered. Learn More
Vehicle Fit
- 2003-2005 Ford Crown Victoria Front or Rear Flint Gray Interior Door Handle Driver Side
- 2003-2005 Mercury Grand Marquis Front or Rear Flint Gray Interior Door Handle Driver Side
- 2003-2004 Mercury Marauder Front or Rear Flint Gray Interior Door Handle Driver Side
This part replaces:
- OE # 3W7Z5421819AAB
- Dorman 81680
