Your idler arm connects to the center link on the passenger side of your steering linkage. Typically it supports the right hand side of your steering linkage by bolting to the frame and pivoting the same as the pitman arm. Over time the greasable ends and even the holes in the arm can wear causing loose connections and a sloppy steering feel.


  • Includes (1) Idler Arm assembly as shown
  • Comes as shown with greasable end
  • Replaces dealer part numbers: 26028523, 26028525, 26059030
  • Direct replacement
  • Built to strict quality control standards

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Remove the wheel (1:00)
    • Loosen the lug nuts.
    • Raise and secure the vehicle
    • Remove the lug nuts and the wheel.
  2. step : Remove the front shield (1:15)
    • Use a 15 mm socket and ratchet.
    • Remove the four bolts.
  3. step : Remove the Idler Arm (1:25)
    • Remove the 24 mm bolt securing the idler arm to the steering linkage
    • Use a joint fork and a hammer to separate the joint.
    • Remove the three other bolts securing the idler arm.
    • Use a Tie Rod Puller to pull apart the idler arm and the idler shaft.
  4. step : Install the new idler arm (4:34)
    • Assemble your new idler arm to your idler shaft, threading on the bushing and nut.
    • Bolt in the idler arm assembly into place, tightening up the three nuts.
    • Bolt in the end of the idler arm assembly to the steering gear.
    • Torque the nuts and bolts to 80 ft lbs.
    • Install the cotter pin.
    • Use a grease gun and fill the grease fitting.
  5. step : Reassembly (7:25)
    • Replace the shield with the four 15mm bolts.
    • Clip the air bag harness back in.
    • Put the wheel back on and lower the car
    • Using a star pattern torque the lug nuts to 120-140 ft lbs

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands
  • Large C-Clamp

  • Ratchets & Related

  • 1/2 Inch Breaker Bar
  • Ratchet
  • Socket Extensions
  • Torque Wrench

  • Sockets - Metric

  • 15mm Socket
  • 18mm Socket
  • 19mm Socket
  • 22mm Socket
  • 24mm Socket

  • Specialty Tools

  • Grease Gun
  • Tie Rod Fork
  • Tie Rod Puller

  • Wrenches - Metric

  • 18mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
1999-2000Cadillac Escalade Cadillac Escalade Idler Arm
1993-1994Chevy Blazer Full Size Chevy Blazer Full Size Idler Arm
1993-1999Chevy C1500 Truck Chevy C1500 Truck Idler Arm
1993-2000Chevy C2500 Truck Chevy C2500 Truck Idler Arm
1993-2000Chevy C3500 Truck Chevy C3500 Truck Idler Arm
1993-1999Chevy K1500 Truck Chevy K1500 Truck Idler Arm
1993-2000Chevy K2500 Truck Chevy K2500 Truck Idler Arm
1993-2000Chevy K3500 Truck Chevy K3500 Truck Idler Arm
1993-1999Chevy Suburban C1500 Chevy Suburban C1500 Idler Arm
1993-1999Chevy Suburban C2500 Chevy Suburban C2500 Idler Arm
1993-1999Chevy Suburban K1500 Chevy Suburban K1500 Idler Arm
1993-1999Chevy Suburban K2500 Chevy Suburban K2500 Idler Arm
1995-1999Chevy Tahoe Chevy Tahoe Idler Arm
2000Chevy Tahoe Chevy Tahoe Idler Arm V8 5.7L Models
1993-1999GMC C1500 Truck GMC C1500 Truck Idler Arm
1993-2000GMC C2500 Truck GMC C2500 Truck Idler Arm
1993-2000GMC C3500 Truck GMC C3500 Truck Idler Arm
1993-1999GMC K1500 Truck GMC K1500 Truck Idler Arm
1993-2000GMC K2500 Truck GMC K2500 Truck Idler Arm
1993-2000GMC K3500 Truck GMC K3500 Truck Idler Arm
1993-1999GMC Suburban C1500 GMC Suburban C1500 Idler Arm
1993-1999GMC Suburban C2500 GMC Suburban C2500 Idler Arm
1993-1999GMC Suburban K1500 GMC Suburban K1500 Idler Arm
1993-1999GMC Suburban K2500 GMC Suburban K2500 Idler Arm
1992GMC Yukon GMC Yukon Idler Arm for Models with Standard Suspension
1993-1999GMC Yukon GMC Yukon Idler Arm
2000GMC Yukon GMC Yukon Idler Arm V8 5.7L Models

This part replaces:

  • Moog K6447
Part #: 1ASIA00004

Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(08:13 min)