Hyundai Elantra Strut & Spring Assembly Front Pair TRQ SCA57091 - 1ASSP00639

In the past, replacing struts required specialized tools to compress, remove and transfer the old spring and mount.  Pre-assembled with all new parts, our complete strut and spring assemblies make this job much quicker and easier for the do-it-yourself mechanic.

Each complete strut & spring assembly contains:

• Upper Strut Mount
• Strut Bearing
• Coil Spring
• Boot & Bumper Kit
• Gas-charged Strut 

Loaded strut & spring assemblies allow for a quicker, safer install than bare struts.  No spring compressor required! 

Includes the matched parts needed. New components over reused parts provide a better ride and save you from having to repair again.

Not all shocks and struts are manufactured the same.  Mixing and matching can result in ride quality issues and decrease the life of the parts.

Over buying the parts individually, or having to search different parts that are correct for your vehicle (because we did it for you!)

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Wheel (2:20)

• Pry off the center cap with a flat blade screwdriver
• Loosen the 21mm lug nuts with the vehicle on the ground
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Remove the lug nuts
• Pull off the wheel

step : Removing the Strut (3:50)

• Remove the bolt(s) from the bottom of the strut
• Disconnect any sensors or hoses
• Turn the wheel
• Remove any nuts from the sway bar link attached to the strut
• Removing the nuts on top of the strut

step : Reinstalling the Strut (7:08)

• Insert the strut into place
• Insert the nuts to the strut to hold it in place
• Knock the bottom of the control arm to knock it into the strut or work the strut into place
• Tighten the two lower bolts to the strut
• Torque the bottom strut bolts
• Reinstall the sway bar link
• Reinstall any harnesses or hoses attached to the strut

step : Reattaching the Wheel (9:03)

• Slide the wheel into place
• Start the lug nuts by hand
• Tighten the lug nuts preliminarily
• Lower the vehicle to the ground
• Torque the lug nuts in a crossing or star pattern
• Reattach the center cap