How to Replace Rear Window Switch 2000-07 Volvo V70

1. step 1 :Removing the Door Panel 0:28

   • Use a small flat blade screwdriver to remove the six door panel clips
   • Use a small flat blade screwdriver and a trim tool to remove the plastic cover from the upper armrest base panel handle mounting screw
   • Use a T25 Torx screwdriver to remove the mounting screw
   • Grab the door panel and lift it up
   • To remove the attached cable, gently pull apart the clips attaching it
   • To disconnect the main switch connector, push down on the connector tab to pull it out

2. step 2 :Removing the Window Switch 2:24

   • Use a small flat blade screwdriver to release the four tabs (there are two on either side) on the window switch and then remove the window switch

3. step 3 :Replacing the Window Switch 2:51

   • Make sure the window switch is facing the right way, line up its tabs, and snap it into place

4. step 4 :Reinstalling the Door Panel 3:03

   • Reinsert the inner handle cable by lining it up with the door panel and snapping it in place
   • Reconnect the window switch connector
   • Push the window lock down and guide the cable back inside before lining up the door panel and pushing it back in place
   • Make sure the door panel clips and mounting hole are lined up before reinserting the six door panel clips (make sure each clip is pushed out before inserting)
   • Use a T25 Torx screwdriver to reinsert the upper armrest base panel handle mounting screw
   • Use the mounting screw plastic cover guides to line up the cover and snap it back into place

Tools needed

• Flat Blade Screwdriver

  Trim Tool Set

  T25 Torx Driver