How to Replace O2 Oxygen Sensor 1997-2004 Chrysler Sebring
Created on: 2013-10-25
Watch this video as we guide you through the process of replacing an 02 sensor on your 97-04 Chrysler Sebring.
-
step 1 :Removing the Oxygen (O2) Sensor
- Disconnect the oxygen sensor wiring harness
- Apply rust penetrant to the O2 sensor
- Remove the O2 sensor with an O2 sensor socket and a ratchet
-
step 2 :Installing the New O2 Sensor
- Twist the new O2 sensor into place
- Tighten the O2 sensor with an O2 sensor socket and a ratchet
- Connect the O2 sensor wiring harness
Tools needed
-
A Piece of Pipe (for leverage)
Socket Extensions
Rust Penetrant
O2 Sensor Socket
Ratchet
1/2 Inch Breaker Bar
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the left bank front or upstream O2 sensor in this 2004 Chrysler Sebring sedan. It's got the 2.7 liter V6 and it's pretty much the same operation for a 2004 through 2006. What you'll need for this repair is a new O2 sensor from 1A Auto, an O2 sensor socket and ratchet with extension, and some penetrating oil.
In order to make your job easier, 1A Auto has put together a kit with the O2 sensor socket and O2 sensor that you'll need to get this job done. You can certainly get it as the kit or you can just get the O2 sensor alone.
Locate the left bank front or upstream O2 sensor there, and the harness. You're basically going to lift up on that little tab and give it a tug. You can use some penetrating oil. I'm using my O2 sensor socket with an extension on my ratchet. I'm using a little breaker bar just because these can be tough to get off, so I'm using a pipe on the end of that to help me free that up. Once I get it free I'm just going to unscrew it until it comes out. Going back in, put your O2 sensor in place and start threading it by hand. Once you've done that you can get your special O2 sensor socket with the extension and ratchet and go ahead and tighten it up. Now you can reinstall that connector into the wiring harness.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Jeep Dodge Chrysler Plymouth Eagle O2 Oxygen Sensor TRQ OSA61652
- Quality Tested - built to a strict level of product standards.
- Installation Tool
- (1) Oxygen Sensor Install Socket
- (1) O2 Oxygen Sensor
How to Replace Downstream O2 Sensor 2007-17 Ford Expedition
This video shows you how to install new TRQ oxygen sensors on your 2007-2017 Ford Expedition.
