How To Replace Ignition Coil Ford 1992-96 F150 F250 F350
Created on: 2012-12-27
Check out this video to learn how to replace the ignition coils on your 92-96 Ford F150/250/350
-
step 1 :Removing the Ignition Coil
- Disconnect the ignition coil wire
- Remove the four 7/32 inch bolts from the ignition coil
- Pry off the ignition coil wiring connector with a flat blade screwdriver
- Pull the ignition coil up and out
-
step 2 :Installing the New Ignition Coil
- Put the new ignition coil into place
- Connect the ignition coil wiring connector
- Insert the four 7/32 inch bolts into the ignition coil
- Connect the ignition coil wire
Tools needed
-
Flat Blade Screwdriver
Ratchet
7/32 Inch Socket
7/32 Inch Wrench
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this vide we're going to show you how to replace the ignition coil on this 1996 Ford F150. This vehicle has the 5.0 liter V8. This procedure is pretty much the same for the 5.0 V8, as well as the 5.8 liter V8. The only tools you'll need are a flat blade screwdriver and a 7/32 inch socket with a ratchet or a wrench.
Looking at the driver's side of the engine compartment, you can see the power brake reservoir and booster there. I'm actually just going to pull this tube out. You don't have to do this. This is just going to make it easier for me to film and for you to have a clear view. Your coil is right here. First you're going to want to twist here, and then there's a little tab right over here. Press that, then pull that right off. Then there's four bolts to remove. You can see I'm kind of laying down on the engine. Use a standard size 7/32 inch socket and remove the four bolts. Fast forward here as I just remove those bolts. Not doing anything else other than just some boring old turning of the wrench. Then there's just a connector right here. Pry up with the screwdriver. Disconnect that, and then the coil comes right up and out.
Reinstallation of new coil is pretty much just the reverse of the procedure. Put the coil in and put the connector right underneath and put your bolts back in. Try to start each one. Fast forward here, again. I start each bolt just with my fingers first, make sure they're going in okay. I make sure I start all four first, then use the 7/32 socket and ratchet and tighten them up. Reconnect it. I'm going to put this back on. Again, I just took that off so I could film. You don't have to take it off. Then, reconnect our coil wire.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Shop Products
Ford Mazda Lincoln Mercury Merkur Ignition Coil TRQ ICA61702
- No
- Male
- 0.44 Ohms
- No
- No
- 7.9 Ohms
- 2
- Female
- Blade
- 30000 VDC
- Direct Replacement
- Black
How to Replace Ignition Coil 1999-2000 Chevy Tahoe
This video shows you how to install a new ignition coil in your 1992-2000 Chevy Tahoe.
