This is a power door lock actuator that mounts inside the door. It is designed to REPLACE a broken or missing unit.

Specifications:

  • LH (Driver Side)
  • Fits either FRONT or REAR as listed by application
  • Electrically operated
  • Correct electrical connection
  • Direct replacement
  • Built to strict quality control standards
This power door lock actuator is a great replacement and has good cost savings over an actuator from the dealer.

Returns Note:

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed.

Part Details

  • Operation: Power

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:53)
    • Pry off the trim piece inside the door pull with a flat blade screwdriver
    • Remove the Phillips head screw inside the door pull
    • Remove the Phillips head screw inside the door handle
    • Pull up the window switch panel and remove the harnesses
    • Pull the door handle forward and out
    • Pull the lock rod up and out from the inside door handle
    • Pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver
    • Release the clips all around from the door panel by pulling out
    • Pull the door panel up and off
    • Disconnect the speaker harness
  2. step : Removing the Door Handle (3:01)
    • Pull the water shield down
    • Remove the plug in the door with a flat blade screw driver
    • Remove three 10mm bolts inside the door with a ratchet and socket extension
    • Shift the exterior handle bracket
    • Remove the Phillips screw from the lock rod clip and disconnect the lock rod
    • One hand on the inside, one on the outside, rotate the bracket until the handle removes
    • Disconnect the lock from the door handle
    • Remove the bushing from the lock rod with a flat blade screwdriver
  3. step : Removing the Lock Assembly (5:17)
    • Remove the 10mm bolt from the lower inside of the door
    • Pull the window track down and out
    • Squeeze the tabs from the door lock actuator plugs and pull them out
    • Remove the three Phillips screws from the lock latch
    • Remove the screw from the door lock button
    • Pull the guide from the lock
    • Pull the latch assembly forward, undo the clip
    • Remove the inside door handle rod and pull the latch assembly out
  4. step : Preparing the Lock Actuator (6:40)
    • Remove the four Phillips screws from the latch assembly
    • Pull the actuator off
    • Line up the new actuator with the lever onto the post underneath
    • Once lined up with the actuator, screw the Phillips screws in
  5. step : Installing the Lock Assembly (7:40)
    • Put the lock button up through the door
    • Pul the lock button back forward and reconnect the latch rod
    • Lock the clip on the latch rod
    • Place the assembly back in the door and tighten the three Phillips screws
    • Insert and tighten the door lock button screw
    • Reconnect the door lock actuator plugs
    • Reconnect the harness to the door switch panel
    • Test the lock assembly
  6. step : Reinstalling the Door Handle (9:19)
    • Install the window track
    • Tighten the 10mm window track bolt
    • Snap the lock rod into the door lock handle with pliers
    • Place the rear end first, slide the handle around the tab, slide and rotate the handle in
    • Slide the handle forward to reconnect the screw and lock rod
    • Tighten the three 10mm bolts on the inside of the door
    • Replace the cap, unlock the door, test the door handle
    • Replace the water shield
  7. step : Reinstalling the Door Panel (11:42)
    • Reconnect the speaker harness
    • Connect the clips all around from the door panel by pulling out
    • Push in the trim piece at the front top corner of the door panel
    • Pull the lock rod up and out from the inside door panel
    • Push in the door handle
    • Push in the window switch panel and remove the harnesses
    • Replace the Phillips head screw inside the door handle
    • Replace the Phillips head screw inside the door pull
    • Push the trim piece inside the door pull

Tools needed for replacement:

    General Tools

  • Flashlight

  • Pliers, Cutters & misc Wrenches

  • Vise Grip Pliers

  • Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

5.0 / 5.0
2 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
2
0
0
0
0
Exactly what I needed
I purchased this for my 2005 Honda Civic LX because the driver door would not open with the remote and the this actuator was the correct one. Great price. I recommend it. I also suggest searching YouTube if you plan on installing it yourself.
December 31, 2017
Purchased
7 months ago
Works perfectly
Not an easy install but the part fit perfect and worked as needed. Great delivery time. No issues
February 28, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Does this part fit a 1990 Honda Accord EX 2 dr coupe driver's side power door?
Terry U on Jan 4, 2017
BEST ANSWER: This part is specific to Accord models from 1998 to 2002. At this time we do not offer the correct power door lock actuator.

Vehicle Fit

Year Make Model Description
1998-2002Honda Accord Honda Accord LX Front Power Door Lock Actuator Driver Side
1998-2002Honda Accord Honda Accord DX Front Power Door Lock Actuator Driver Side
2002-2006Honda CR-V Honda CR-V (UK Built Models (1st VIN Digit S)) Front Power Door Lock Actuator Driver Side
2001-2005Honda Civic Honda Civic SI Front Power Door Lock Actuator Driver Side
2001-2005Honda Civic Honda Civic 4 Door Front Power Door Lock Actuator Driver Side
1999-2004Honda Odyssey Honda Odyssey LX Front Power Door Lock Actuator Driver Side

This part replaces:

  • OE # 72155S84A11
  • OE # 72155S5AA01
  • Dorman 746-362
Part #: 1ADLA00089


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(12:33 min)