Honda Civic Radiator & A/C Condenser Cooling Fan Assembly Pair - 1ARFK00015

Our aftermarket A/C condenser and radiator cooling fan assemblies are some of the highest quality replacements on the market!


  • Comes as a PAIR
    • LH (Driver Side) and RH (Passenger Side)
  • New, not rebuilt, electric motors
  • Geometrically designed plastic blade for optimal circulation and uniform balance
  • Shroud designed to ensure structural integrity and endurance for maximum performance
  • 100% Performance factory tested
  • Replaces original assemblies that are melted or worn out
  • Comes with proper plug(s) for trouble free installation

Now you can buy a high quality cooling fan motor assembly pair that is built to strict quality control standards. This cooling motor assembly set makes a great replacement and has substantial cost savings over a dealer fan kit.

Returns Note:

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed.

Part Details

  • Quantity: Pair

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

    Before starting this repair, make sure that your engine is cool

  1. step : Draining the Coolant (0:43)
    • Make sure the engine is cool
    • Place a drain pan beneath the coolant drain plug
    • Twist the coolant drain plug
    • Let the coolant drain
    • Remove the radiator cap
  2. step : Removing the Battery (1:27)
    • Loosen the negative battery cable with a 10mm wrench
    • Loosen the positive batter cable with a 10mm wrench
    • Pull the clip from the mounting bolt
    • Remove the mounting bolts with a 10mm wrench
    • Remove the battery mount
    • Remove the battery cover
    • Lift the battery up and out
    • Remove the lower battery retainer
  3. step : Removing the Coolant Overflow Bottle (2:20)
    • Remove the 10mm bolt from the coolant overflow bottle
    • Lift the reservoir up and out, unclipping the hose as you go
    • Pry off the retaining clip from the lower hose
    • Twist and pull the hose off
  4. step : Removing the Radiator Cooling Fan (3:00)
    • Place a drip pan underneath the coolant hose
    • Remove the 10mm bolt from the ground wire
    • Loosen the coolant hose clamp with pliers
    • Remove the coolant hose
    • Remove the two 10mm bolts from the radiator fan assembly
    • Disconnect the fan assembly wiring harness
    • Disconnect the coolant temperature sensor
    • Pull the radiator fan assembly up and out
    • Remove the center cover from the old fan
  5. step : Installing the Radiator Cooling Fan (5:11)
    • Insert the center cover to the new fan
    • Insert the cooling fan down into place
    • Connect the fan wiring harness
    • Tighten the 10mm mounting bolts to the top of the fan
    • Reconnect the coolant temperature sensor
    • Insert the coolant hose into place
    • Tighten the coolant hose clamps
    • Tighten the 10mm ground bolt
  6. step : Reinstalling the Coolant Overflow Bottle (7:08)
    • Insert the hose into place
    • Tighten the hose clamp to the hose with a pair of pliers
    • Clip the hose to the bottle
    • Insert the coolant bottle into its slot
    • Tighten the 10mm bolt to the bottle
  7. step : Installing the Battery (8:14)
    • Insert the lower battery retainer
    • Insert the battery into place
    • Replace the battery cover
    • Insert the battery mount into place
    • Reinstall the 10mm bolts
    • Connect the positive battery cable with a 10mm wrench
    • Connect the negative battery cable with a 10mm wrench
  8. step : Refilling the Coolant (8:52)
    • Tighten the drain plug
    • Insert a funnel into the radiator opening
    • If you are reusing coolant, filter the coolant with a t-shirt
    • Replace the radiator cap

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • Rust Penetrant

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
Radiator cooling fans
I have no complaints. They came in a timely manner. The quality look as good as the ones from factory. They seems to be working just fine.
July 7, 2018
2 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2001 Honda Civic (excluding Japan Built Models) Radiator & A/C Condenser Cooling Fan Assembly Pair for Models with Nippondenso Style Radiator
  • 2002 Honda Civic 4 Door Sedan Radiator & A/C Condenser Cooling Fan Assembly Pair
  • 2002-2005 Honda Civic 2 Door Coupe Radiator & A/C Condenser Cooling Fan Assembly Pair
  • 2003-2005 Honda Civic 4 Door Sedan Radiator & A/C Condenser Cooling Fan Assembly Pair (excluding Hybrid Models)

This part replaces:

  • Partslink HO3113114
  • Hollander 674-59603
  • OE # 38616PMMA01
  • Dorman 620-220
  • Dorman 620-219
  • Hollander 674-59604
  • Partslink HO3115115
Only 1 left in stock
Part #: 1ARFK00015

Order must be placed by 4pm ET

How-to Video:

(08:21 min)