Replaces

Honda Civic Jeep Wrangler Heater Blower Motor with Fan Cage - 1AHCX00250

This Honda blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 79310-SNA-A02, 79310-SNA-A01, 79310SNAA02, 79310SNAA01
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Blower Motor (0:21)
    • Pop the three clips out of the lower dash trim
    • Pull the lower dash trim down and off
    • Disconnect the blower motor electrical connector
    • Remove the three T20 Torx screws from the blower motor
    • Pull the blower motor out of the heater box
  2. step : Installing the Blower Motor (2:06)
    • Line up the blower motor tab with the heater box
    • Slide the blower motor into place
    • Insert the three T20 screws into the blower motor
    • Connect the blower motor electrical connector
    • Put the lower dash trim into place using the locating tabs
    • Push the three clips onto the lower dash trim

Tools needed for replacement:

    Screwdrivers & Related

  • Flat Blade Screwdriver

  • Torx Drivers & Sockets

  • T20 Torx Driver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
The description says its for a 2008 honda...but when i put in 2010 jeep..this one pops up...will this fit my jeep?
Dean S on Jan 1, 2018
BEST ANSWER: This part is specific to vehicles with a particular set of options. We will need more information about your vehicle to confirm the fit. Please feel free to call our customer service department for clarification @ 888-844-3393.

Vehicle Fit

  • 2006-2011 Honda Civic Heater Blower Motor with Fan Cage
  • 2007-2010 Jeep Wrangler Heater Blower Motor with Fan Cage

This part replaces:

  • OE # 79310SNAA02
  • OE # 79310SNAA01
  • Hollander 615-50106
  • TYC 700194
Part #: 1AHCX00250

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(03:33 min)