Honda Civic Grille - 1ABGR00574

This replacement grille is just what you need to get your vehicle in good looking form again!

Specifications:

• Brand New Grille
• Chrome
• High quality injection molded plastic
• Replaces dealer part number: 71122SNAA00, 71122-SNA-A00
• Direct replacement
• Built to strict quality control standards
• Does not include emblem

This grille makes a great replacement and offers good value over the dealer unit.

NOTE: It is necessary to reuse your original hardware, as new hardware is not included with this item.

Item Condition: New

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Front Bumper (0:20)

• Pop out the clips from the splash shield beneath the bumper cover
• Remove the Phillips screw from the opening on the wheel well edge
• Pry up the push clips from the radiator shield
• Pull the lip of the radiator shield back from the grillee
• Remove the pins from the side trim to slide the shield out
• Remove the shield
• Remove the T35 Torx from the grille
• Pry out the sides of the bumper cover
• Remove the bumper cover

step : Removing the Grille (4:23)

• Remove the 8mm bolts from the grille
• Remove the grille

step : Removing the Emblem (6:37)

• Remove the T35 Torx screw from the emblem
• Press the tabs and release the emblem
• Remove the one way washers with a pick

step : Installing the Emblem (8:20)

• Press the washers onto the tabs
• Press the emblem into the chrome strip
• Tighten the T35 Torx screw to the emblem

step : Installing the Grille (9:23)

• Transfer the bolts over to the new grille
• Insert the grille into place
• Tighten the 8mm bolts to the grille

step : Installing the Front Bumper (10:59)

• Lift the bumper cover up into place
• Snap the bumper cover into place
• Tighten the T35 Torx bolts to the grille
• Push on the radiator shield
• Press on the clips to the side trim
• Press on the clips to the shield
• Tighten the Phillips screw in the opening on the wheel well edge
• Pop on the clips from the splash shield beneath the bumper cover