This Chrysler 300, Dodge Magnum, & Charger heater blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part number: 5061091AB
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

 

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

 

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Blower Motor (0:47)
    • Remove the plastic clips from underneath the dash with a trim tool
    • Pull down the carpeted panel under the dash
    • Disconnect the bower motor wiring harness
    • Remove the four 8mm bolts from the blower motor
    • Pull out the blower motor
    • Unclip the wiring harness retainers with a trim tool
  2. step : Installing the Blower Motor (4:26)
    • Clip the wiring harness retainers to the blower motor
    • Put the blower motor into place
    • Install the four 8mm bolts for the blower motor
    • Connect the blower motor wiring harness
    • Put the carpet into place
    • Push the plastic clips into the carpet

Tools needed for replacement:

    Ratchets & Related

  • Ratchet
  • Socket Extensions

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 8mm Socket

  • Specialty Tools

  • Trim Tool Set

4.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
0
1
0
0
0
Packing issues
The blower works well and installation was easy . The problem was that when I opened the box I found that one of the tabs used to hold the wiring harness was broken. Luckily I was still able to make the harness work
May 3, 2017
Purchased
1 year ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2005-2007 Chrysler 300 Heater Blower Motor with Fan Cage
  • 2006-2007 Dodge Charger Heater Blower Motor with Fan Cage
  • 2005-2007 Dodge Magnum Heater Blower Motor with Fan Cage

This part replaces:

  • Hollander 615-00682
  • OE # 5061091AB
  • Partslink CH3126121
  • TYC 700176
  • DEPO 333-58007-000
Part #: 1AHCX00230

Out of Stock

How-to Video:

(05:53 min)