This Audi TT & VW Beetle, Golf, & Jetta heater blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 1J1819021A, 1J1 819 021 A, 1J1819021B, 1J1 819 021 B, 1J1819021C, 1J1 819 021 C
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality control testing .  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Accessing the Blower Motor (0:35)
    • Remove the three T20 Torx bolts from underneath the glove box
    • Open the glove box
    • Remove three T20 bolts from the top of the glove box
    • Pull off the glove box side panel by hand
    • Remove the T20 Torx bolt from the side console panel
    • Pull the glove box panel back
    • Lift the glove box panel up and out
    • Disconnect the wiring harness from the glove box
  2. step : Removing the Blower Motor (1:49)
    • Pull the soundproofing aside
    • Pull away the insulation below the blower motor
    • Disconnect the blower motor resistor wiring harness
    • Remove the two 6mm bolts from the blower motor resistor
    • Pull the wiring harness out of its clip
    • Disconnect the blower motor wiring harness
    • Pull the blower motor resistor down and out
    • Slide the blower motor down and out
  3. step : Installing the New Blower Motor (2:28)
    • Push the new blower motor up into place
    • Push the blower motor resistor into place
    • Insert the two 6mm bolts into the blower motor resistor
    • Connect the blower motor resistor wiring harness
    • Push the insulation into place
    • Push the wiring harness onto its clip
    • Connect the blower motor wiring harness
    • Pull the soundproofing into place
  4. step : Reinstalling the Glove Box (3:50)
    • Connect the wiring harness to the glove box
    • Slide the glove box panel under the console side panel
    • Insert the T20 bolt into the console side panel
    • Insert the three T20 bolts into the bottom of the glove box
    • Open the glove box
    • Insert the three T20 bolts into the top of the glove box
    • Push on the side glove box panel

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 6mm Socket

  • Torx Drivers & Sockets

  • T20 Torx Driver

5.0 / 5.0
4 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
4
0
0
0
0
Blower purchase
Have done business with 1A before. Always happy with parts. Shipping is always great with part arriving sooner that expected. Will be using 1A again.
October 26, 2017
Purchased
4 months ago
Easy swap
The part was delivered quickly and the video on how to replace the blower motor was spot on. My son and I had it swapped in less than 30 minutes. Hardest part were the clips holding in the glove box, not the actual blower. It slid into place like it was an original part. I will buy all my parts here if they are as good as this one.
December 25, 2017
Purchased
2 months ago
Blower Fan Replacement
The part came at a good price and was delivered as promised. Using the youtube video posted by 1A Auto Parts, I was able to fairly easily install the fan into my 2002 Jetta in around an hour. And it works like a charm! Will definitely use 1A Auto parts again in the future, great service!
January 10, 2018
Purchased
1 month ago
Jetta blower motor
Installing the blower on My Volkswagen Jetta was easier than I thought. Watching the video on the website shows step by step how to install it. I also bought the heater resistor as well because the old blower motor burned out the resistor due to worn brushes. I bought with confidence because !AAuto guranteed the parts purchased woud fit my 2004 Jetta.
March 30, 2017
Purchased
11 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(05:14 min)

Tools List:

    Ratchets & Related

  • Ratchet

  • Sockets - Metric

  • 6mm Socket

  • Torx Drivers & Sockets

  • T20 Torx Driver



This part replaces:

  • Hollander 615-58478
  • OE # 1J1 819 021 C
  • TYC 700158

Vehicle Fit

  • 2000-2006 Audi TT Heater Blower Motor with Fan Cage
  • 2000-2006 Audi TT Quattro Heater Blower Motor with Fan Cage
  • 1998-2010 VW Beetle Heater Blower Motor with Fan Cage
  • 1999 VW Golf Hatchback Heater Blower Motor with Fan Cage (8th Vin Digit J)
  • 2000-2002 VW Golf Hatchback Heater Blower Motor with Fan Cage
  • 2003-2005 VW Golf Heater Blower Motor with Fan Cage
  • 2006-2009 VW Golf Heater Blower Motor with Fan Cage (8th Vin Digit J)
  • 1999 VW Jetta Heater Blower Motor with Fan Cage (8th Vin Digit M)
  • 2000-2004 VW Jetta Heater Blower Motor with Fan Cage
  • 2005 VW Jetta Heater Blower Motor with Fan Cage (8th Vin Digit J or M)
  • 2006 VW Jetta Wagon Heater Blower Motor with Fan Cage
  • 2007-2008 VW Jetta Sedan Heater Blower Motor with Fan Cage (8th Vin Digit M)
Part #: 1AHCX00215

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More