This Ford Lincoln Mercury blower motor with fan cage is a new, aftermarket replacement part. It is just what you need to bring your heating and A/C blower system back to good working order! This assembly has the following

Specifications:

  • New, not remanufactured or rebuilt
  • Includes blower motor fan cage impeller already installed
  • Direct replacement
  • Replaces dealer part numbers: 1W7Z-19805-BA, EOTZ-19834-A, 1W7Z19805BA, EOTZ19834A
  • Built to strict quality control standards
  • 100% tested prior to leaving the factory

Note: Due to the wide range of vehicles and years that this blower motor fits, in some instances, the original fan cage may need to be swapped and used in place of the cage that comes with this assembly.

If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Our electrical and electronic parts are subject to strict quality control testing .  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Blower Motor (0:37)
    • Remove the top two 8mm bolts from the blower motor
    • Disconnect the blower motor wiring lead
    • Pull the wiring aside
    • Remove the lower two 8mm bolts from the blower motor
    • Disconnect the tube that runs from the motor to the firewall
    • Pull the blower motor up and out
  2. step : Installing the New Blower Motor (2:11)
    • Put the gasket on to the blower motor
    • Line up the hole on the blower motor bracket with the line-up stud
    • Push the blower motor down into place
    • Make sure the gasket is lined up correctly
    • Start one of the top bolts by hand
    • Start the two lower bolts by hand
    • Tighten the lower two bolts
    • Remove the top bolt
    • Put the wiring harnesses into place
    • Insert the two top bolts
    • Reconnect the blower motor wiring lead
    • Reinstall the tube that runs from the motor to the firewall

Tools needed for replacement:

    Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Sockets - Metric

  • 8mm Socket

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Heater fan
The fan was an exact fit. The instruction video made it simple and quick to install the heater fan. I would recommend 1AAuto
to my friends.
Larry - Richmond Virgiba
January 11, 2018
Purchased
1 month ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(05:24 min)

Tools List:

    Ratchets & Related

  • Socket Extensions
  • Ratchet

  • Sockets - Metric

  • 8mm Socket



This part replaces:

  • OE # EOTZ 19834 A
  • OE # 1W7Z 19805 BA
  • Hollander 615-00463
  • TYC 700014

Vehicle Fit

  • 1980-1986 Ford Bronco Heater Blower Motor with Fan Cage for Models with Factory Installed Air Condtioning
  • 1979-2011 Ford Crown Victoria Heater Blower Motor with Fan Cage
  • 1980-1986 Ford F100 Truck Heater Blower Motor with Fan Cage for Models with Factory Installed Air Condtioning
  • 1980-1986 Ford F150 Truck Heater Blower Motor with Fan Cage for Models with Factory Installed Air Condtioning
  • 1980-1986 Ford F250 Truck Heater Blower Motor with Fan Cage for Models with Factory Installed Air Condtioning
  • 1980-1986 Ford F350 Truck Heater Blower Motor with Fan Cage for Models with Factory Installed Air Condtioning
  • 1979-1982 Ford LTD Heater Blower Motor with Fan Cage
  • 1980-1983 Lincoln Mark VI Heater Blower Motor with Fan Cage
  • 1980-1997 Lincoln Town Car Heater Blower Motor with Fan Cage
  • 1979-2011 Mercury Grand Marquis Heater Blower Motor with Fan Cage
  • 2003-2004 Mercury Marauder Heater Blower Motor with Fan Cage
Part #: 1AHCX00056

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More