Heater Blower Motor with Fan Cage Four Seasons - 1AHCX00013

This blower motor with fan cage is a new, aftermarket replacement part. If you are experiencing intermittent stopping during use, squealing noise from bearings, or poor air flow from your dash vents this may be your solution.

Specifications:

• 1 Spade Terminal
• Includes Fan Cage Impeller
• New not remanufactured
• Direct replacement
• Built to strict quality control standards
• Fits models with Factory Installed A/C (Air Conditioning)
• Fits models with 3/4" Return Air Hole only
• Fits models with 4" Deep Fan Cage only

For some vehicles the blower motor is different depending if your car is equipped with Air Conditioning (A/C) or not. Whenever possible match up the specifications of the blower motor with your original, to ensure you are getting the correct one.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Left Hand Drive Note:

“All of our auto parts are intended for Left Hand Drive USDM vehicles and might not have been tested on Right Hand Drive platforms. If your vehicle is Right Hand Drive, please do your research prior to making a purchase to ensure the part is correct for your specific vehicle.”

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Remove the blower motor. (0:54)

• Unplug the lead and unscrew the 6mm nut attaching the ground wire.
• Unbolt the five bolts securing the blower motor in the air box.
• Use a flex joint and socket and ratchet to reach the bottom bolt

step : Remove air box (1:26)

• Undo the clips on each side of the air box and move it out of the way.
• Lift the filter up and out.
• Lift the airbox up firmly and use a screwdriver to pop out the clips.
• Pull the airbox out towards the center of the car.
• Set it aside.

step : Install the new blower motor (2:10)

• Seat the new blower motor into it's housing.
• Bolt it back in with your socket and ratchet.
• Attach the ground strap and bolt it in.
• Plug in the lead.

step : Test the blower motor (4:42)

• Turn on the car and test the new blower motor.