Replaces

GMC Envoy Envoy XL Tail Light Circuit Board - 1ALTL00313

This Tail light circuit connector board is just what you need to get your Tail light working again!

Specifications:

  • LH (Driver Side) or RH (Passenger Side)
  • High quality item that is built to strict quality control standards
  • Direct bolt on ~ Easy to install
  • Replaces burnt and malfunctioning circuit board
  • Allows for just replacement of defective part instead of entire Tail light

This Tail light circuit connector board makes a great replacement and has good cost savings over a dealer circuit board.

 

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Removing the Taillight (0:40)
    • Open the lift gate
    • Remove the two Phillips screws from the taillight bracket
    • Disconnect the headlight wiring harness
  2. step : Removing the Circuit Board and Servicing the Bulbs (1:04)
    • Remove the three Phillips screws from the circuit board
    • Pull the circuit board out
    • Pull the bulb off of the socket
    • Push on the new bulb
    • Push the bulb onto the socket
    • Push the circuit board into the light
    • Insert and tighten the three Phillips screws into the circuit board
  3. step : Installing the New Taillight (2:15)
    • Push in the tabs on the plate on the old taillight and remove it
    • Connect the plate to the new taillight
    • Reconnect the wiring harness to the taillight
    • Line up the bolt holes on the taillight bracket to the bolt holes on the vehicle
    • Replace the two Phillips screws into the taillight bracket

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
1
0
0
0
0
Shop 1A Auto for all your parts needs!
1A always has exactly what I need, for a great price, they stand by their products and will replace if something goes wrong. THEY ARE THE BEST in online parts, and if you don't know how to install them the videos are a life saver!
November 3, 2017
Purchased
6 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2002-2009 GMC Envoy Tail Light Circuit Board Driver or Passenger Side
  • 2002-2006 GMC Envoy XL Tail Light Circuit Board Driver or Passenger Side

This part replaces:

  • Hollander 166-1961
  • OE # 16532716
  • Dorman 923-011
  • Partslink GM2817106
  • TYC 11-6029-20
Only 3 left in stock
Part #: 1ALTL00313

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(03:14 min)