Replaces
Ford Taurus Mercury Sable Steering Kit - 1ASFK02889
1ASFK02889Specifications:
- Brand New Steering Kit
- Comes as a 6 Piece Kit
- Fits LH (Driver Side) & RH (Passenger Side)
- Direct Replacements
- Built to strict quality control standards
Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.
Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards. Failure to do so may result in issues with steering and premature tire wear.
Direct FitAll parts are direct fit, application-specific parts with no modifications required
Rigorously TestedRigorously tested and made from higher quality materials than the competition. Our parts are built to have a longer life in any environment or road conditions.
State of the Art ManufacturingOur parts are manufactured by some of the same factories that the OEMs use.
Prepackaged for Your ConvenienceOur kits have been carefully put together to include all of the parts you need to get the job done, saving you both time and money. These kits also help take the guesswork out of finding the correct part for your vehicle’s steering or suspension system, allowing you to get started on your repair project faster.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Step 1: Remove wheel (2:25)
- Remove lug nuts and remove wheel.
-
step : Step 2: Remove tie rod (2:37)
- Remove cotter pin.
- Use your tie rod puller to pull the tie rod up.
- Use your two adjustable wrenches to remove the tie rod.
-
step : Step 3: Install new tie rod (5:30)
- Use the old nut to mark the bolt with tape.
- Use a vice grip and an adjustable wrench to remove the nut, using penetrating oil if need be.
- Replace bolt with new one, compensating for any difference in width.
- Use your two adjustable wrenches to tighten the nut up against the tie rod end.
- Use your torque wrench to tighten up the nut on the end of the tie rod and put the cotter pin in.
- Put the grease fitting in.
- Use grease gun to fill boot with grease.
-
step : Step 4: Put wheel back on (9:48)
- Use the star pattern to tighten the lugs to 90 to 100 ft lbs.
Tools needed for replacement:
- Needle nose pliers
- Adjustable Wrench
- Ratchet
- 18mm Socket
- 19mm Socket
- Grease Gun
- Tie Rod Puller
- Vise-Grips
- 8mm Wrench
Pliers, Cutters & misc Wrenches
Ratchets & Related
Sockets - Metric
Specialty Tools
Wrenches - Metric
Vehicle Fit
- 1996-2007 Ford Taurus 6 Piece Set Steering Kit
- 1996-2005 Mercury Sable 6 Piece Set Steering Kit
This part replaces:
- Moog K8465
- OE # E69Z3332A,E7FZ3332A
- Moog ES3349RL
- Moog EV398