Ford Taurus Mercury Sable Mirror Pair - 1AMRP00101

Specifications:

• Comes as a Pair
  • Fits both LH (Driver Side) & RH (Passenger Side)
• Power operation
• Injection molded black plastic housing
  • Includes textured black and smooth black caps
  • Smooth cap can be painted by the buyer to any color desired or installed as is
• Direct replacements
• Built to strict quality control standards

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Special Note:

• Unless otherwise noted, replacement mirrors will only work properly on vehicles with the exact same options. If your vehicle does not have the options listed in specifications, the mirror(s) may not function properly.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Removing the Door Panel (0:58)

• Remove the 7 Phillips screws around the door panel.
• Pull the clips out along the edges of the door panel.
• Pull the door panel up and out.
• Disconnect the harnesses.

step : Removing the Side Mirror (2:41)

• Pry out the plug on the triangular panel.
• Remove the two 6mm bolts.
• Remove the plastic cover.
• Disconnect the mirror harness.
• Remove the 11mm nuts.
• Pull the mirror out and off.

step : Replacing the Side Mirror (3:56)

• Feed the harness down through the door.
• Line up the mirror and push it into place. Push the top first and then the bottom.
• Replace the 11mm nuts.
• Reconnect the harness.
• Replace the triangular panel and the 6mm bolts.
• Replace the plug.

step : Replacing the Door Panel (5:27)

• Reconnect the harnesses to the door panel.
• Put the door panel down into place.
• Hit the clips in around the door panel.
• Replace the 7 Phillips screws.