This replacement parking light trim is just what you need to get your vehicle in good looking form again!

Specifications:

  • RH (Passenger Side)
  • Mounts in the corner of the fender
    • also known as side grille molding
  • Replaces dealer part numbers: F37Z-16160-A, F57Z-16160-CB, F37Z16160A, F57Z16160CB
  • Chrome Finish
  • Injection molded plastic
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
NOTE: For 1993-94 Models: This trim piece fits 2WD (Two Wheel Drive) XLT models only. It does NOT fit 4WD (Four Wheel Drive), XL, or STX Models.

This parking light trim makes a great replacement and offers good cost savings over the dealer unit.

Note:

It is necessary to reuse your original hardware, as new hardware is not included with this item.

Part Details

  • Color: Chrome

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Grille (0:40)
    • Remove the six Phillips screws on the grille
    • Pull the grille up and out
  2. step : Removing the Parking Light (1:35)
    • Remove the 11mm nut from the parking light
    • Pull out the parking light
    • Disconnect the wiring harness
  3. step : Servicing the Bulb (2:20)
    • Twist the bulb socket counterclockwise out of the light
    • Pull the bulb off of the socket
    • Push on the new bulb
    • Twist the bulb clockwise into the light
  4. step : Removing the Headlight Trim (2:28)
    • Remove the 11mm bolt on top of the trim
    • Remove the two Phillips screws on the side of the trim
    • Remove the trim
  5. step : Installing the Headlight Trim (3:26)
    • Insert the trim into place
    • Tighten the two Phillips screws to the side of the trim
  6. step : Installing the Parking Light (4:42)
    • Connect the wiring harness
    • Line up the studs on the parking light with the holes on the vehicle
    • Tighten the 10mm bolt to the parking light
  7. step : Reinstalling the Grille (5:41)
    • Insert the grille into place
    • Tighten the 11mm bolt to the top of the trim
    • Tighten the six Phillips screws to the grille

Tools needed for replacement:

    Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 11mm Socket
  • 10mm Socket

  • Wrenches - Metric

  • 11mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1993-1994 Ford Ranger XLT 2 Wheel Drive Chrome Headlight Trim Molding Passenger Side
  • 1995-1997 Ford Ranger Chrome Headlight Trim Molding Passenger Side

This part replaces:

  • OE # F37Z16160A
  • OE # F57Z16160CB
  • Partslink FO1213103
Part #: 1ALHB00008

How-to Video:

(07:49 min)