This replacement Ford Truck parking light is just what you need to get your truck in good looking form again!

Specifications

  • LH (driver's side)
  • Injection molded plastic
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Mounts below the headlight
  • Does not include bulbs or wiring

This Ford Truck parking lamp is a great replacement and has good cost savings over a corner light from the dealer.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Uses same wiring as original assembly.  No cutting or splicing required.

DOT and SAE Compliant

Meets federal regulations for on-road use

Part Details

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Servicing the Bulbs (0:37)
    • Twist the bulb socket counterclockwise out of the light
    • Pull the bulb off of the socket
    • Push on the new bulb
    • Twist the bulb clockwise into the light
  2. step : Removing the Light Assembly (1:50)
    • Remove the two 10mm nuts from the assembly
    • Remove the two Phillips screws from the top of the light
    • Pull the light assembly forward
    • Disconnect the two sockets from the lights
  3. step : Removing the Parking Light (3:54)
    • Remove the 11mm bolt from the marker light brace
    • Remove the three Phillips screws from the parking light
  4. step : Installing the New Parking Light (4:34)
    • Insert the parking light into place
    • Tighten the three Phillips screws to the light
    • Tighten the 11mm bolt to the marker light brace
  5. step : Installing the Light Assembly (5:54)
    • Connect the two sockets to the lights
    • Insert the assembly into place
    • Tighten the two Phillips screws to the top of the light
    • Remove the two 10mm nuts from the assembly

Tools needed for replacement:

    Screwdrivers & Related

  • Phillips Head Screwdriver

  • Sockets - Metric

  • 10mm Socket
  • 11mm Socket

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1992-1996 Ford Bronco Parking Light Driver Side
  • 1992-1996 Ford F150 Truck Parking Light Driver Side
  • 1992-1996 Ford F250 Truck Parking Light Driver Side
  • 1997 Ford F250 Truck Parking Light Driver Side
  • 1992-1997 Ford F350 Truck Parking Light Driver Side
  • 1992-1997 Ford F450 Truck Parking Light Driver Side

This part replaces:

  • Partslink FO2520116
  • Hollander 116-858L
  • OE # F5TZ 13201 AB
  • TYC 12-1470-01
  • DEPO 331-1612L-US
Part #: 1ALPK00064

How-to Video:

(06:42 min)