Ford Lincoln Mercury Jaguar O2 Oxygen Sensor with Install Tool

This Oxygen O2 Sensor is a new, aftermarket replacement part that has the following specifications:

• Four wire, four pin O2 sensor
• Correct wire length (8 Inches)
• Upstream Sensor
• Direct Fit
  -Correct Connector
  -No cutting or splicing
• Replaces dealer part numbers: 5C5Z9F472AA, 5C5Z-9F472-AA, 5C5Z9F472BA, 5C5Z-9F472-BA, 9L17, XC2Z9F472AA, XC2Z-9F472-AA, XC2Z9F472BA, XC2Z-9F472-BA, XZ2Z9F472AA, XZ2Z-9F472-AA
• Anti-Sieze coating on thread
• Built and tested to strict quality control standards
• Some applications use (2) of the same Oxygen Sensors Upstream and Downstream
• Includes removal and installation tool

Note: For clarification purposes:

• Upstream location is between the catalytic converter and the engine
• Downstream location is between the catalytic converter and the tailpipe

A direct replacement. If you have a bad O2 sensor causing your vehicle to idle poorly or fail an emission test then this is the part for you.

Our electrical and electronic parts are subject to strict quality testing.

Parts cannot be returned after they have been installed. Contact us with any questions before installing the parts.

Item Condition: New

Attention California Customers:

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Identifying your Oxygen Sensors (0:57)

• Upstream oxygen sensors are located in between the engine and the catalytic converter
• Downstream oxygen sensors are located in the catalytic converter or farther away from the engine than the catalytic converter
• Locate your vehicle's firing order diagram
• The bank that contains cylinder one is bank one
• The bank that does not contain cylinder one is bank two, even if it does not contain cylinder two