This replacement Toyota and Geo Exterior door handle is just what you need to get your Toyota and Geo in good working form again!

Specifications:

  • RH (Passenger Side) REAR DOOR
  • Injection molded TEXTURED black plastic
  • Durable construction
  • Steel center rod and return spring
  • Direct replacement for original handle
  • Fits 4 door sedan and station wagon models only

This Toyota and Geo exterior door handle is a direct bolt on and is built to strict quality control standards. It is a great replacement and has substantial cost savings over a dealer unit.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Remove the door panel (0:27)
    • Remove the Phillips screw in the inside door handle.
    • Unclip the door latch rod.
    • Pry up the corner panel on the inside side of the side mirror.
    • With your screwdrivers, pry up the top of the door pull and remove the two Phillips screws.
    • Pry up the switch panel and unplug it.
    • Use a putty knife to unclip the door panel from the door.
    • Carefully peel back the water shield.
  2. step : Remove the outside door handle (2:30)
    • Unbolt the four 10 mm bolts and the one nut to remove the bracket in the door.
    • Reach into the door and unclip the lock and latch rods from the door handle.
    • Remove the two 10 mm bolts in the door handle.
    • Pull the lock cylinder out .
    • Remove the door handle.
  3. step : Install the new door handle (4:51)
    • Start bolting in the door handle, putting the lock cylinder in before you finish bolting down the far bolt.
    • Clip in the lock and latch rods to the door handle.
    • Bolt that bracket back in with your 10 mm socket and ratchet.
  4. step : Put the door panel back on (7:25)
    • Clip the door panel in, threading the wiring connectors through the door pull.
    • Fasten all the Phillips screws.
    • Plug in the wiring harness to the switch panel.
    • Clip the switch panel and top of the door pull down.
    • Connect the door latch with the lock and latch rods.

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 10mm Socket

  • Wrenches - Metric

  • 10mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1993-1997 Geo Prizm Exterior Door Handle Black Textured Rear Passenger Side
  • 1993-1997 Toyota Corolla Exterior Door Handle Black Textured Rear Passenger Side
  • 1996-2000 Toyota Rav4 Exterior Door Handle Black Textured Rear Passenger Side

This part replaces:

  • DEPO 312-50004-001
Part #: 1ADHE00418

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(09:20 min)