Replaces
This part doesn’t fit a . Select from parts that fit.
Light Assembly Lifetime Warranty
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you tail light replacement. This is a 2008 Dodge 1500 and same for a 2007-2008 1500, 2007-2009 2500 and 3500 and the only things you'll need is new tail light from 1AAuto.com and a T25 Torx driver.
Open up your tailgate. Each light has two screws. These are T25 Torx. It's best to have a socket like this and a ratchet handle. With those screws out, grab it right in behind here and pull. We're going to pull this little clip off and put it back in the bed of the truck.
If you're just looking to change your bulbs, turn counterclockwise and pull out. Obviously, the light is now free and these bulbs just pull out and push back in. If you needed to disconnect your connections, there's just tabs on the side. You would use a small flat blade screwdriver and press the tabs on that one. This one just pull this little red safety tab down and this tab and disconnect.
Push the safety tab on, and our original light is in good shape, so we're just going to reinstall it. Put the lower one in clockwise to lock, upper one in, and clockwise to lock. Just peak in and make sure that these go into the hole. Just push the light in and put your two T25 Torx screws back in place.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
