Replaces
This part doesn’t fit a . Select from parts that fit.
Light Assembly Lifetime Warranty
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com your source for quality replacement parts and the best service on the Internet.
In this video, we're going to show you how to remove and replace your tail light assembly. We'll show you both replacing the tail light assembly as well as if you just need to change a bulb, the procedure for that. This is pretty much the same for any 2002 to 2006 Ram.
Tools you'll need are a T25 torx driver, a flat blade screwdriver, and a Phillips screwdriver if you are replacing a bulb.
Okay, first, you want to remove the tail light. T25 torx bit, there's two screws, one here and one down here. As soon as I pull that one out the light starts moving. Then you pull over here with this hand on the edge, and basically two pins here that lock into holes there. You need a flat blade screwdriver. There's a locking tab here, just push it down and out and then push on the tab here and remove that harness. If you're just looking to change the bulbs, undo four Phillips screws. Okay, we'll fast-forward through removing those four screws.
And this connector plate comes out. The bulbs just detach like that. Okay, and again we'll fast-forward as we just put those four screws back into place and tighten them down nice and snug. So now a new light from 1A Auto. Exactly the same. If you've broken your taillight it's a perfect fix, goes right in. Comes in. Locking tab. Pushes right into place. Start one screw, start the other screw. Nice and snug, they don't have to be extremely tight. You're all set.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
Tools used
