Dodge Tail Light - 1ALTL00033

This tail lamp features the following specifications:

• LH (Driver Side)
• Replaces dealer part number: 5EK45DX8AC
• Includes lens & Housing
• DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
• Direct replacement
• Correct for Sport Models that have a BLACK BEZEL

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

Direct fit replacement for OEM assembly

Uses same wiring as original assembly.  No cutting or splicing required.

Meets federal regulations for on-road use

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

step : Remove the tail light assembly (0:23)

• Open the tail gate
• Unbolt the two T25 screws anchoring the tail light assembly.
• Disconnect the wiring harness and remove the bulbs.
• Service your bulbs at this point or put your bulbs in the new tail light assembly.

step : Install the tail light assembly (1:19)

• Plug in the bulbs and wiring harness.
• Clip the tail light assembly into the vehicle.
• Replace the T25 Torx screws.
• Close the tail gate