These inner ties are just what you need to ensure the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Comes as a PAIR
    • Fits both the LH (Driver Side) & RH (Passenger Side) FRONT INNER
  • Replaces dealer part numbers: 52106405AC, 52106405AI, 52106405AJ
  • Direct replacements
  • Built to strict quality control standards
  • Fit 4WD (Four Wheel Drive) Models only

Remember whenever you are replacing any front end or steering components you should have your vehicle professionally aligned as soon as possible. This will ensure proper tracking and even tire wear.

Our steering and suspension components are sealed for long life and do not require the extra maintenance typically required by greasable versions.

Please Note: Whenever replacing steering components, it is highly recommended to have a professional alignment performed on the vehicle afterwards.  Failure to do so may result in issues with steering and premature tire wear.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:38)
    • Loosen the 22mm lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Outer Tie Rod (1:49)
    • Loosen the 24mm nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
    • Remove the 22mm nut from the outer tie rod end
    • Strike the steering knuckle with a hammer to loosen the outer tie rod
    • Pull the outer tie rod out of the steering knuckle
    • Twist off the outer tie rod by hand
  3. step : Installing the New Outer Tie Rod (3:49)
    • Twist the new outer tie rod onto the inner tie rod
    • Push the outer tie rod into the steering knuckle
    • Fasten the 22mm castle nut onto the outer tie rod
    • Torque the nut to 45 foot-pounds, then torque to an additional 90 degrees
    • Push the cotter pin through the castle nut
    • Twist the cotter pin into place with needle nose pliers
    • Tighten the 24mm nut that holds the outer tie rod to the inner tie rod with an adjustable wrench
  4. step : Reattaching the Wheel (5:08)
    • Slide the wheel into place
    • Start the 22mm lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to between 135 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Floor Jack

  • Ratchets & Related

  • Ratchet
  • Torque Wrench
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Sockets - Metric

  • 22mm Socket

  • Wrenches - Metric

  • 24mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2000-2004 Dodge Dakota Tie Rod Inner Front 4 Wheel Drive Pair
  • 2000-2003 Dodge Durango Tie Rod Inner Front 4 Wheel Drive Pair

This part replaces:

  • Moog EV432
  • OE # 52106405AC, AI, AJ
Part #: 1ASFK01117

Ships Same Day for orders placed by 4 P.M. ET

How-to Video:

(06:11 min)