This replacement Dodge Dakota or Durango corner parking light is just what you need to get your Dodge in good looking form again!


  • LH (Driver Side)
    • Mounts below and beside the headlight
  • Injection molded plastic
  • DOT (Department of Transportation) & SAE (Society of Automotive Engineers) approved
  • Direct replacement
  • Does not include bulbs or wiring

This Dodge Dakota or Durango parking lamp is a great replacement and has good cost savings over a parking light from the dealer.

Direct Fit Replacement

Direct fit replacement for OEM assembly

Trouble-free Installation

Light uses same wiring as the original assembly, providing easy, trouble-free installation.  No cutting or splicing required.

DOT and SAE Compliant

DOT & SAE compliant: meets federal regulations for on-road use

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

Bulb Note:

Unless otherwise noted, our lights do not include bulbs, though occasionally lighting manufacturers do include bulbs in the lights. If you happen to receive a lighting product (Headlight, Tail light, parking light, fog light etc.) that comes with the bulbs, the bulbs are not covered under our warranty. Our warranty applies only to the light assembly.

  1. step : Removing the Parking Light (1:11)
    • Pull the rubber lighting gasket off of its pins
    • Remove the T10 Torx screw at the bottom of the headlight
    • Pull the parking light out by hand
    • Twist the parking light bulbs
    • If necessary, replace the bulbs
  2. step : Installing the New Parking Light (2:28)
    • Insert the bulbs into the new parking light
    • Twist the bulbs in to secure them
    • Push the parking light up and to the side against the headlight
    • Make sure the parking light bracket teeth clip into place
    • Insert the T10 Torx Screw
    • Stretch the gasket back on to the pins
    • Close the hood slowly, while pushing the gasket in

Tools needed for replacement:

    Torx Drivers & Sockets

  • T10 Torx Driver

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 1997-2004 Dodge Dakota Corner Light Driver Side
  • 1998-2003 Dodge Durango Corner Light Driver Side

This part replaces:

  • Partslink CH2520135
  • Hollander 116-1039L
  • OE # 55055173AD
  • TYC 12-5006-90-1
  • DEPO 333-1614L-US-Y
Part #: 1ALTL00122

How-to Video:

(05:04 min)