Replaces

Control Arm with Ball Joint Passenger Side - 1ASLF00302

This replacement front lower control arm with ball joint is just what you need to bring back the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Fits RH (Passenger Side) FRONT LOWER
  • Includes Ball Joint & Bushings
  • Replaces dealer part numbers: 7L2Z3078AB, 7L2Z 3078 AB
  • Direct replacement
  • Built to strict quality control standards

Worn or loose bushings can cause excessive front tire wear, popping or creaking in the front end, extra play in the steering system, and pose a serious safety concern. Replace that control arm with the loose bushings with our high quality replacement.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Removing the Wheel (0:46)
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Sway Bar Links (1:13)
    • Hold the upper link stud with a 16mm wrench
    • Remove the lower nut from the link with a 16mm socket and ratchet
    • Remove the sway bar link
    • Tap the sway bar link out with a hammer if it's stuck
    • Remove the bushings and washers
  3. step : Removing the Control Arm (2:40)
    • Remove the 24mm bolt from the strut
    • Remove the 24mm lower ball joint nut
    • Strike the side of the steering knuckle with a hammer
    • Remove the 24mm nut fixed in the subframe on the rear of the lower control arm
    • Loosen the 30mm axle socket with a socket and 24mm wrench
    • Tap out the bolt
    • Pry the control arm down
    • Pry the control arm out of the steering knuckle
  4. step : Installing the Control Arm (4:46)
    • Install the lower ball joint into the knuckle
    • Hand-tighten the 24mm nut to the ball joint
    • Set the control arm into the frame
    • Set the rear bolts into the frame and control arm
    • Push down on the spindle
    • Line up the bottom strut bolt
    • Tighten the 24mm strut bolt
    • Tighten the 24mm bolt on the backside
    • Tighten the 30mm bolt on the backside
    • Torque the lower ball joint nut to 111 foot-pounds
    • Jack up underneath the knuckle to simulate the ride height
    • Torque the strut bolt to 248 foot-pounds
    • Torque the 30mm bolt to 296 foot pounds
    • Torque the back 24mm rear control arm to 148 foot-pounds
  5. step : Installing the Sway Bar Links (8:14)
    • Place a washer onto the link
    • Then a bushing
    • Place the link up through the control arm
    • Install a bushing with the tapered end down
    • Then a washer
    • Then the sleeve
    • Then a washer with the cup facing up
    • Then a bushing with the tapered end up
    • Insert the link into the sway bar
    • Install a bushing
    • Install a washer
    • Then tighten the nut with a 17mm wrench and a 16mm socket and ratchet
    • Lower the jack/weight from the suspension
  6. step : Reattaching the Wheel (9:43)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Hammer
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • Safety Glasses
  • Gloves

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Screwdrivers & Related

  • Pry Bar

  • Sockets - Metric

  • 24mm Socket
  • 19mm Socket
  • 16mm Socket
  • 30mm Socket

  • Wrenches - Metric

  • 17mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

How-to Video:

(10:28 min)

Tools List:

    General Tools

  • Jack Stands
  • Hammer
  • Floor Jack

  • Materials, Fluids, and Supplies

  • Rust Penetrant
  • Safety Glasses
  • Gloves

  • Ratchets & Related

  • Ratchet
  • Socket Extensions
  • 1/2 Inch Breaker Bar

  • Screwdrivers & Related

  • Pry Bar

  • Sockets - Metric

  • 24mm Socket
  • 19mm Socket
  • 16mm Socket
  • 30mm Socket

  • Wrenches - Metric

  • 17mm Wrench



This part replaces:

  • OE # 7L2Z3078AB
  • Dorman 520-388
  • Moog K80720

Vehicle Fit

  • 2006-2010 Ford Explorer Front Lower Control Arm with Ball Joint Passenger Side
  • 2007-2010 Ford Explorer Sport Trac Front Lower Control Arm with Ball Joint Passenger Side
  • 2006-2010 Mercury Mountaineer Front Lower Control Arm with Ball Joint Passenger Side
Part #: 1ASLF00302

Ships Same Day for orders placed by 4 P.M. ET

We're here to help

1A Auto Parts

Customer Feedback

"Thanks for the fast reliable service. Great price, and the headlights were as good as oem or better!!! Keep up the good work..."
- Dwuan M.
Read More