Replaces

Control Arm with Ball Joint MOOG RK80942 - MGSFU00006

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

    NOTE: After completing the procedure you will need a professional alignment

  1. step : Removing the Wheel (0:47)
    • Loosen the 22mm caps on the hubcap with the vehicle on the ground
    • Pull the hubcap free
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Upper Control Arm (1:10)
    • Mark the tab on the adjustment piece with a marker to mark the alignment
    • Remove the two 10mm bolts holding the brake line and move the brackets
    • Remove the ball joint nut with an 18mm wrench
    • Hit the wheel knuckle and control arm to break them free
    • Remove the 21mm nuts from the upper control arm bracket
    • Jack up the wheel underneath the wheel knuckle
    • Remove the upper control arm nut
    • Remove the bolts and upper control arm bracket
    • Place a nut back on and use an air hammer to knock the bolt out if it won't budge
    • Move the control arm up and down while pulling out
  3. step : Installing the Upper Control Arm (3:52)
    • Put the upper control arm into place and push the 21mm bolts in to hold it
    • Put the brackets on either side and realign them up
    • Angle the control arm down into the wheel knuckle
    • Replace the 18mm ball joint nut
    • Replace the 21mm nuts from the upper control arm bracket
    • Replace and tighten the two 10mm bolts
    • Put a grease gun into place on the end of the control arm and fill it up
  4. step : Reattaching the Wheel (6:00)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 ft/lbs in a crossing or star pattern
    • Reattach the hubcap and tighten the caps

Tools needed for replacement:

    General Tools

  • Hammer
  • Jack Stands

  • Materials, Fluids, and Supplies

  • Marker / Writing Utensil

  • Ratchets & Related

  • Ratchet
  • Torque Wrench

  • Sockets - Metric

  • 10mm Socket
  • 21mm Socket
  • 22mm Socket

  • Specialty Tools

  • Grease Gun

  • Wrenches - Metric

  • 18mm Wrench
  • 21mm wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

Year Make Model Description
2002-2006Cadillac Escalade Cadillac Escalade Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2003-2006Cadillac Escalade ESV Cadillac Escalade ESV Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2002-2006Cadillac Escalade EXT Cadillac Escalade EXT Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2002-2006Chevy Avalanche 1500 Chevy Avalanche 1500 Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2003-2014Chevy Express 1500 Van Chevy Express 1500 Van Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2003-2005Chevy Express 2500 Van Chevy Express 2500 Van 7300LB GVW Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
1999-2000Chevy Silverado 1500 Chevy Silverado 1500 Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2001-2003Chevy Silverado 1500 Chevy Silverado 1500 (excluding Crew Cab) Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2004-2006Chevy Silverado 1500 Chevy Silverado 1500 6 Lug Wheels Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2007Chevy Silverado 1500 Classic Chevy Silverado 1500 Classic 6 Lug Wheels Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2000-2006Chevy Suburban 1500 Chevy Suburban 1500 Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2000Chevy Tahoe Chevy Tahoe (excluding Z71 Models) Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2001-2006Chevy Tahoe Chevy Tahoe Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2003-2014GMC Savana 1500 Van GMC Savana 1500 Van Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2003-2005GMC Savana 2500 Van GMC Savana 2500 Van 7300LB GVW Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
1999-2000GMC Sierra 1500 GMC Sierra 1500 Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2001-2003GMC Sierra 1500 GMC Sierra 1500 (excluding Crew Cab) Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2004-2006GMC Sierra 1500 GMC Sierra 1500 6 Lug Wheels Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2007GMC Sierra 1500 Classic GMC Sierra 1500 Classic 6 Lug Wheels Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2000GMC Yukon GMC Yukon Control Arm with Ball Joint (excluding Denali Models) Upper Driver or Passenger Side MOOG RK80942
2001-2006GMC Yukon GMC Yukon Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942
2000-2006GMC Yukon XL 1500 GMC Yukon XL 1500 Upper Control Arm with Ball Joint Driver or Passenger Side MOOG RK80942

This part replaces:

  • MOOG RK80942
  • OE # 15864153
Part #: MGSFU00006


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

MOOG
Brand #: RK80942

How-to Video:

(07:07 min)