Description
Warranty & Shipping
How-To & Tools
Product Reviews
Q&A
Vehicle Fit

This replacement front upper control arm is just what you need to bring back the safety and integrity of your vehicle's suspension and steering.

Specifications:

  • Fits Driver Side Front Upper control arm
  • Includes new inner bushings
  • Replaces dealer part number:15858682
  • Control arm is new, not remanufactured or refurbished

Worn ball joints or loose rear bushings can cause excessive front tire wear, popping or creaking in the front end, extra play in the steering system, and pose a serious safety concern. Replace that heavily rusted, rotted, or damaged front upper control arm with the loose bushings or worn ball joints with our high quality all in one replacement.

One way to diagnose a loose, or warn ball joint on a control arm, is to jack the car up, so the wheel is off of the ground, then have someone try to move the wheel in and out. While they are moving the wheel check the ball joint and bushings for play, if it is moving you probably need to replace it.

Our control arms are designed to be direct replacements for the original factory parts.  They are 100% brand new and require no modifications for installation.  No special tools are required because all of the bushings come pre-installed.

Item Condition: New

Attention California Customers:

WARNING:  This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm.  For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Wheel (0:41)
    • Pry off the center cap with a flat blade screwdriver
    • Loosen the lug nuts with the vehicle on the ground
    • Raise the vehicle with a floor jack
    • Secure the vehicle on jack stands
    • Remove the lug nuts
    • Pull off the wheel
  2. step : Removing the Control Arm (1:03)
    • Apply penetrating oil to the 15mm bolt that holds the control arm to the steering knuckle Remove the 15mm bolt that holds the control arm to the steering knuckle
    • Pry the brake line from its clips with a flat blade screwdriver
    • Strike the control arm with a hammer to separate it from the steering knuckle
    • Secure the knuckle with wire ties, wire, or string
    • Apply penetrating oil to the two 21mm control arm bolts
    • Remove one 21mm bolt from the control arm
    • Loosen the other 21mm bolt
    • Push out the second 21mm bolt with a hammer and a flat blade screwdriver
    • Pull off the control arm
    • Strike the remaining bolt out of the control arm with a hammer
  3. step : Installing the New Control Arm (3:52)
    • Pry the brake line clips out of the control arm with a flat blade screwdriver
    • Push the new control arm into place
    • Start the two 21mm bolts into the control arm
    • Tighten the two 21mm bolts preliminarily
    • Remove whatever is securing the wheel knuckle
    • Put the control arm onto the wheel knuckle
    • Tap the control arm onto the wheel knuckle using a hammer
    • Start the 15mm bolt and nut that hold the control arm to the steering knuckle
    • Tighten the 15mm bolt to 50 foot-pounds of torque
    • Push the brake line clips onto the new control arm
    • Clip the brake line into the clips
  4. step : Reattaching the Wheel (6:11)
    • Slide the wheel into place
    • Start the lug nuts by hand
    • Tighten the lug nuts preliminarily
    • Lower the vehicle to the ground
    • Tighten the lug nuts to 100 foot-pounds in a crossing or star pattern
    • Reattach the center cap

Tools needed for replacement:

    General Tools

  • Jack Stands
  • Floor Jack
  • Hammer

  • Materials, Fluids, and Supplies

  • Wire Ties
  • Rust Penetrant
  • Wire or String

  • Pliers, Cutters & misc Wrenches

  • Wire Cutters
  • Needle nose pliers

  • Ratchets & Related

  • Torque Wrench
  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver

  • Sockets - Metric

  • 15mm Socket
  • 19mm Socket

  • Wrenches - Metric

  • 21mm wrench
  • 15mm Wrench

There are no reviews for this item.
Will this fit my car? Add a vehicle to make sure
Customer Q&A
Ask a question to 1A Auto customers who purchased the product
No questions have been asked about this item.
Year Make Model Description
2004-2007Buick Rainier Buick Rainier Front Upper Control Arm Driver Side
2003-2006Chevy SSR Chevy SSR Front Upper Control Arm Driver Side
2002-2009Chevy Trailblazer Chevy Trailblazer Front Upper Control Arm Driver Side
2002-2006Chevy Trailblazer EXT Chevy Trailblazer EXT Front Upper Control Arm Driver Side
2002-2009GMC Envoy GMC Envoy Front Upper Control Arm Driver Side
2002-2006GMC Envoy XL GMC Envoy XL Front Upper Control Arm Driver Side
2004-2005GMC Envoy XUV GMC Envoy XUV Front Upper Control Arm Driver Side
2003-2008Isuzu Ascender Isuzu Ascender Front Upper Control Arm Driver Side
2002-2004Oldsmobile Bravada Olds Bravada Front Upper Control Arm Driver Side
2005-2009Saab 9-7X Saab 9-7X Front Upper Control Arm Driver Side
Part #: 1ASFU00019


Order must be placed by 4pm ET

Get it in: 2 - 4 Business Days

Want it sooner? Choose Next Day Air at Checkout

How-to Video:

(07:28 min)