This combination cruise control, wiper, high beam and turn signal switch lever is a new, aftermarket replacement part. It is designed to REPLACE original units that are prone to failure. It's just what you need to get your vehicle in good working order again!

Specifications:

  • Replaces dealer part number: 12450067
  • Direct replacement
  • Design improved for more durability
  • Detailed graphics
  • Built to strict quality control standards
  • Fits models with Cruise Control

This combination lever is designed to replace your original with no modifications necessary.

Our electrical and electronic parts are subject to strict quality control testing.  Once the item has been installed or plugged in, it is no longer eligible for a refund.  The item may be eligible for replacement, only if it is found to have a manufacturing defect. Before purchasing, please ensure proper diagnosis of the failed original part is performed

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.

  1. step : Disconnecting the Battery (0:46)
    • Disconnect the negative battery cable with an 8mm socket and ratchet
  2. step : Removing the Dash Panels (0:59)
    • Remove the two 7mm bolts from the panel below the dash
    • Pull down the panel below the dash
    • Remove the four 7mm bolts from the lower dash panel
    • Pull the lower dash panel down and off
    • Pry the tilt lever out of the steering wheel with a flat blade screwdriver
    • Remove the two Phillips screws from the bottom of the instrument panel trim
    • Lower the steering wheel
    • Remove the two Phillips screws from the top of the instrument panel trim
    • Pull the instrument panel trim forward, up, and out
    • If any white caps fall off the instrument panel trim, put them back on
  3. step : Removing the Turn Signal Switch ([2:35)
    • Remove the two T25 Torx bolts from the steering column panel
    • Pry the steering column panel down with a flat blade screwdriver
    • Pull off the lower steering column panel
    • Raise the steering wheel
    • Remove the E5 inverted Torx screw from the steering column
    • Pull off the upper steering column panel
    • Disconnect the turn signal switch wiring harnesses
    • Remove the two T25 screws from the turn signal switch
    • Pull off the turn signal switch
    • Disconnect the wiring harness from the back of the turn signal switch
  4. step : Installing the New Turn Signal Switch (5:11)
    • Apply white grease to the turn signal switch mounting point
    • Connect the wiring harness to the back of the turn signal switch
    • Push the turn signal switch into place using the locating tab
    • Insert the two T25 screws into the turn signal switch
    • Connect the remaining turn signal switch wiring harnesses
  5. step : Testing the Turn Signal Switch (6:13)
    • Reconnect the negative battery cable
    • Turn the vehicle on
    • Test all the functions of the turn signal switch
    • Turn the vehicle off
    • Disconnect the negative battery cable
  6. step : Reinstalling the Dash Panels (6:45)
    • Put the top steering column panel into place
    • Raise the steering wheel
    • Insert the E5 bolt into the steering column
    • Clip on the lower steering column panel
    • Insert the two T25 bolts into the steering column panel
    • Lower the steering wheel
    • Push in the instrument panel trim
    • Insert the four Phillips screws into the instrument panel trim
    • Lift the lower dash panel into place
    • Insert the four 7mm bolts into the lower dash panel
    • Push the panel below the dash into place
    • Insert the two 7mm bolts into the panel below the dash
    • Reconnect the negative battery cable if you have not already done so

Tools needed for replacement:

    Materials, Fluids, and Supplies

  • White Grease

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Flat Blade Screwdriver
  • Phillips Head Screwdriver

  • Sockets - Metric

  • 7mm Socket
  • 8mm Socket

  • Torx Drivers & Sockets

  • E5 Inverted Torx Socket
  • T25 Torx Driver

  • Wrenches - SAE

  • 1/4 Inch Wrench

4.9 / 5.0
29 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
27
1
1
0
0
combo switch
thank you for your low price and the part showed up on time and exact fit
April 23, 2018
Purchased
2 months ago
Awsome
Great customer service over the phone and the videos are extremely helpful!
April 13, 2018
Bright lights on turn signal
Replaced turn signal switch because of bright would come on. New switch working great problem gone. Video help out too
March 11, 2018
Purchased
4 months ago
Good price
Good price. The right part them first time. fast shipping I will buy again thank you.
March 10, 2018
Purchased
4 months ago
Super easy insall
I was hesident at the start to replace this in my 2006 GMC Sierra being I am a YouTube mechanic. However it was super easy, took all of 30mins, which 15 of is was figuring out how to take apart the dash. Once I realized it was just snapped in, it went easy. The part is identical as the original, and now It is fixed and my headlights to turn on to brights every time I use my turning indicator.
January 25, 2018
Purchased
5 months ago
exact part
The part was identical to the original. And the video was really close to what i had to do to replace the switch.
January 6, 2018
Purchased
6 months ago
Turn signal-03 Tahoe
Replaced the turn signal on my 03 Tahoe. New signal works great. I no longer have the issue of turning right and having the high beams go on. I would absolutely recommend 1A Auto. Also, it arrived early!
December 27, 2017
Purchased
6 months ago
Blinker stalk for escalade
Quick shipping and cheaper then other retailers. Part fit perfect, works awesome.
December 20, 2017
Purchased
6 months ago
Great buy at at great price!
I bought this for my 07 Silverado classic that the high beams turned on every time I used the turn signals, this new lever fixes that and feels firm and new. It was a direct replacement and the install was pretty simple after watching 1A's install video. This is not my first or my last prchace from 1AAuto.
December 17, 2017
Purchased
6 months ago
Love the service
One small detail was that I had to drill. The hole. So it can aligned to the holes in the vehicle
December 14, 2017
Purchased
6 months ago
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 5 questions Browse 5 questions and 12 answers
I have a 2005 chevy Silverado 4.8l V8 base without cruise control. I ordered this part because I was told that i could just install it and it woul add cruise control. I have taken everything off and removed the old turn signal but the old one does not have the little black wire that comes out of the new one. Where would this go? I looked around in the wiring around the steering wheel but could not find it. ANy help would be much appreciated
Shane G on Jul 13, 2016
BEST ANSWER: I'm not a mechanic, but I can almost guarantee you that there is a lot more required to get cruise control than this switch. Good luck.
Who is the manufacturer of this part?
Thomas M on Nov 3, 2015
BEST ANSWER: Sorry, but it's been awhile since I put it in. I don't think it was AC Delco, but it works fine and very easy to put in. It wasn't the problem though, the problem was the turn signal module. There video's online to fix just about anything if you have a little mechanic skills.
THIS LEAVER COMES WITH ALL SWITCHES INSTALLED IN IT ---TURN-CRUSE CONTROL-WIPER SWITCH?
quicky on Nov 24, 2017
BEST ANSWER: Sure does i installed one on a 2008 trailblazer.
I have a 2002 GMC 2500HD with out cruise control.can I put a cruise control combination switch in to have cruise control. Is the wiring all ready in the truck to hook it up?
Ralph R on Apr 26, 2018
BEST ANSWER: This part will not add cruise control to your vehicle. This will only be a correct replacement for vehicles with cruise from the factory.
I just installed this turn signal on my 2003 GMC Yukon denali. My right turn signal was not working. After I installed it before I put everything back together I tested everything and it all worked fine. Then I put it all back together and now the right turn signal and the right flasher are not working. Any ideas?
Melanie on Feb 6, 2017
BEST ANSWER: We are sorry to hear the issue you are experiencing. It could be that once everything was put back together a wire may be cut or exposed causing a short on the right turn signal and flasher. Please call us at 1-888-844-3393 so we may further assist you.

Vehicle Fit

  • 2004-2007 Buick Rainier with Cruise Control Combination Switch
  • 2003-2006 Cadillac Escalade with Cruise Control Combination Switch
  • 2003-2006 Cadillac Escalade ESV with Cruise Control Combination Switch
  • 2003-2006 Cadillac Escalade EXT with Cruise Control Combination Switch
  • 2003-2006 Chevy Avalanche 1500 with Cruise Control Combination Switch
  • 2003-2006 Chevy Avalanche 2500 with Cruise Control Combination Switch
  • 2003-2006 Chevy SSR with Cruise Control Combination Switch
  • 2003-2006 Chevy Silverado 1500 with Cruise Control Combination Switch
  • 2007 Chevy Silverado 1500 Classic with Cruise Control Combination Switch
  • 2003 Chevy Silverado 1500 HD with Cruise Control Combination Switch
  • 2005-2006 Chevy Silverado 1500 HD with Cruise Control Combination Switch
  • 2007 Chevy Silverado 1500 HD Classic with Cruise Control Combination Switch
  • 2003-2004 Chevy Silverado 2500 with Cruise Control Combination Switch
  • 2003-2006 Chevy Silverado 2500 HD with Cruise Control Combination Switch
  • 2007 Chevy Silverado 2500 HD Classic with Cruise Control Combination Switch
  • 2003-2006 Chevy Silverado 3500 with Cruise Control Combination Switch
  • 2007 Chevy Silverado 3500 Classic with Cruise Control Combination Switch
  • 2003-2006 Chevy Suburban 1500 with Cruise Control Combination Switch
  • 2003-2006 Chevy Suburban 2500 with Cruise Control Combination Switch
  • 2003-2006 Chevy Tahoe with Cruise Control Combination Switch
  • 2002-2009 Chevy Trailblazer with Cruise Control Combination Switch
  • 2002-2006 Chevy Trailblazer EXT with Cruise Control Combination Switch
  • 2002-2009 GMC Envoy with Cruise Control Combination Switch
  • 2002-2006 GMC Envoy XL with Cruise Control Combination Switch
  • 2004-2005 GMC Envoy XUV with Cruise Control Combination Switch
  • 2003-2006 GMC Sierra 1500 with Cruise Control Combination Switch
  • 2007 GMC Sierra 1500 Classic with Cruise Control Combination Switch
  • 2003 GMC Sierra 1500 HD with Cruise Control Combination Switch
  • 2005-2006 GMC Sierra 1500 HD with Cruise Control Combination Switch
  • 2007 GMC Sierra 1500 HD Classic with Cruise Control Combination Switch
  • 2003-2004 GMC Sierra 2500 with Cruise Control Combination Switch
  • 2003-2006 GMC Sierra 2500 HD with Cruise Control Combination Switch
  • 2007 GMC Sierra 2500 HD Classic with Cruise Control Combination Switch
  • 2003-2006 GMC Sierra 3500 with Cruise Control Combination Switch
  • 2007 GMC Sierra 3500 Classic with Cruise Control Combination Switch
  • 2003-2006 GMC Yukon with Cruise Control Combination Switch
  • 2003-2006 GMC Yukon XL 1500 with Cruise Control Combination Switch
  • 2003-2006 GMC Yukon XL 2500 with Cruise Control Combination Switch
  • 2003-2007 Hummer H2 with Cruise Control Combination Switch
  • 2003-2008 Isuzu Ascender with Cruise Control Combination Switch
  • 2002-2004 Olds Bravada with Cruise Control Combination Switch

This part replaces:

  • Hollander 629-00403
  • OE # 12450067
  • Standard Motor Products CBS-1149
Part #: 1AZCC00166

How-to Video:

(08:36 min)