Replaces

Chrysler Aspen Dodge Durango Exterior Door Handle - 1ADHE00762

This replacement exterior door handle is just what you need to get your vehicle in good looking form again!

Specifications:

  • Fits LH (Driver Side) REAR DOOR
  • Smooth Black Finish
    • can be painted by buyer to match or installed as is
  • Replaces dealer part number: 1EH611XRAA
  • Durable construction
  • Direct replacement
  • Built to strict quality control standards

This exterior door handle is a great replacement and has good cost savings over a dealer unit.

Paint To Match Note:

"Paint to match finish" refers to a smooth, paintable surface. This item will be shipped unpainted but will be ready for paint. Final preparation is suggested for better paint coverage and adhesion. 

This part can also be installed without painting if desired. 

Part Details

  • Color: Black
  • Finish: Smooth - Paint to Match

Lifetime Warranty

This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser.

  1. step : Removing the Door Panel (0:37)
    • Pry off the trim piece inside the door handle with a flat blade screwdriver
    • Remove the Phillips head screw inside the door handle
    • Remove the two Phillips screws at the bottom of the door panel
    • Pry out the door panel with a door panel clip tool or putty knife
    • Lift the door panel up and off
    • Remove the clip from the door lock rod
    • Remove the door lock rod
    • Disconnect the window wiring harness
  2. step : Removing the Door Handle (1:46)
    • Carefully peel back the water shield
    • Unclip the lock rod from the door handle
    • Remove the two 8mm nuts from the door handle
    • Pull the door handle off from the outside
  3. step : Installing the Door Handle (3:14)
    • Unclip the lock rod from the old handle
    • Clip the lock rod onto the new handle
    • Put the handle into place
    • Fasten the two 8mm nuts onto the door handle
    • Clip the lock rod into place
    • Put the water shield into place
  4. step : Reinstalling the Door Panel (5:01)
    • Connect the window wiring harness
    • Connect the door lock rod to the door handle
    • Reclip the clip to the door lock rod
    • Lift the door panel into place
    • Push in the door panel clips
    • Insert the two Phillips screws at the bottom of the door panel
    • Insert the Phillips head screw inside the door handle
    • Push on the trim piece inside the door handle

Tools needed for replacement:

    General Tools

  • Putty Knife

  • Ratchets & Related

  • Ratchet

  • Screwdrivers & Related

  • Phillips Head Screwdriver
  • Flat Blade Screwdriver

  • Sockets - Metric

  • 8mm Socket

  • Specialty Tools

  • Door Panel Removal Tool

  • Wrenches - Metric

  • 8mm Wrench

There are no reviews for this item. Write Review
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Vehicle Fit

  • 2007-2009 Chrysler Aspen Rear Smooth - Paint to Match Black Exterior Door Handle Driver Side
  • 2004-2009 Dodge Durango Rear Smooth - Paint to Match Black Exterior Door Handle Driver Side

This part replaces:

  • OE # 1EH611XRAA
  • Dorman 82054
Part #: 1ADHE00762

How-to Video:

(07:04 min)