Replaces
Chrysler 300 Dodge Magnum Mirror - 1AMRE03340
1AMRE03340Specifications:
- Fits RH (Passenger Side)
- Power
- Heated
- Manual Folding
- Chrome Cap
- Injection Molded Black Plastic Housing
- Direct Replacement
Special Note:
- This mirror will only work properly on vehicles with these exact options. If your vehicle does not have the options listed, the mirror may not function properly.
Lifetime Warranty
This item is backed by a Limited Lifetime Warranty. In the event this item should fail due to manufacturing defects during intended use, we will exchange the part free of charge (excludes shipping charges) for the original purchaser. Please keep your invoice for proof of this warranty.
-
step : Removing the Door Panel (0:45)
- Pry out the trim piece inside the door handle
- Remove the Phillips screw behind the handle
- Remove the circle clips by pressing in the center and prying out the clip
- Remove the four Phillips head screws on the bottom of the panel
- Pry out the panel below the door pull
- Pry out the door panel with a door panel clip tool or putty knife
- Release the door handle cable by popping the clip, rotating the handle, and popping the hook out
- Disconnect the window switch wiring harnesses
- Pop out the wire harness retainers
- Unplug the courtesy light and its wire retainers
- Lift the door panel up and off
-
step : Removing the Chrome Trim (3:18)
- Pry out the black clips by pressing the center
- Remove the black trim panel along the top of the window frame
- Remove the two T25 screws from the trim panel
- Lift up and slide the chrome trim toward the rear
-
step : Removing the Mirror (4:15)
- Disconnect the electrical connector
- Remove the three 8mm nuts from the mirror
- Remove the mirror
-
step : Installing the Mirror (5:48)
- Insert the mirror into place
- Tighten the three 8mm nuts to the mirror
- Connect the electrical connector
-
step : Installing the Chrome Trim (6:24)
- Line up and press the trim into place
- Tighten the T25 Torx screw to the trim
- Press the black clips into the frame
- Press the window frame trim into place
-
step : Installing the Door Panel (7:51)
- Connect the courtesy light
- Clip in the wire harness retainers
- Connect the window switch wiring harnesses
- Insert the latch rod into the door handle
- Slide the clip over the latch rod
- Lift the panel up over the door lock
- Press the panel into place
- Press the clips into the door panel
- Tighten the four Phillips screws to the bottom of the panel
- Tighten the Phillips screws beneath the door pull
- Tighten the Phillips screw into the door handle
- Press on the trim buttons
Tools needed for replacement:
- Pick
- Ratchet
- Socket Extensions
- Phillips Head Screwdriver
- 8mm Socket
- Trim Tool Set
- T25 Torx Driver
General Tools
Ratchets & Related
Screwdrivers & Related
Sockets - Metric
Specialty Tools
Torx Drivers & Sockets
Vehicle Fit
- 2005-2010 Chrysler 300 Power Heated Manual-Folding Chrome Mirror Passenger Side
- 2005-2008 Dodge Magnum Power Heated Manual-Folding Chrome Mirror Passenger Side