Chevy Pontiac Olds Front Wheel Bearing & Hub Assembly Timken 513137 - TKSHF00001

Specifications:

• Brand New Timken Hub Assembly
• Fits either LH (Driver Side) or RH (Passenger Side) Front
• 3 Bolt Flange
• Fits 5 Lug Wheel
• Wheel mounting studs already installed
• Includes ABS sensor and plug wire

Note:
These parts are authentic Timken brand products that are supplied and packaged by Timken.   In some cases, Timken will source parts from other high quality suppliers such as SKF and Koyo. These parts are subjected to the very same testing and quality standards as all Timken products.

Item Condition: New

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge.

step : Removing the Wheel (1:18)

• Loosen the 19mm lug nuts with the vehicle on the ground
• Raise the vehicle with a floor jack
• Secure the vehicle on jack stands
• Remove the lug nuts
• Remove the 35mm hub nut
• Pull off the wheel

step : Removing the Brake Caliper (1:50)

• Remove the two 13mm bolts from the caliper
• Pry off the caliper
• Remove the brake rotor

step : Removing the Hub (3:26)

• Remove the three bolts that hold in the hub
• Disconnect the ABS sensor if you have one
• Reach in behind and remove the clip holding the hub
• For the center, use a large axle nut socket
• Once the center bolt is removed, simply pull the hub off the axle shaft
• If it doesn't come off, you'll need an axle puller or a gear puller. Do not use a hammer

step : Installing the Hub (9:26)

• Once the new hub is ready, place it into position on the axle shaft
• Take the original bolts and reattach the hub

step : Step 5: Replacing the hub (9:26)

• Once the new hub is ready, place it into position on the axle shaft.
• Take the original bolts and reattach the hub.